Epson Equity 320SX PLUS User Manual - Page 129
CHAP-7 INSTALLING AND REMOVING DISK DRIVES, subassembly and cover. Then see Post-installation Setup
View all Epson Equity 320SX PLUS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Installing and Removing Disk Drives The instructions in this chapter describe how to install and remove optional Epson drives in your computer. You can use these instructions to install a variety of devices, including diskette drives, hard disk drives, and tape drives. Although your drive may look a bit different from the one illustrated here, you install it the same way. If you are installing or removing a non-Epson drive, some of the steps in this chapter may not apply; see the documentation that came with your drive for more information. Before you perform any of the procedures described below, follow the steps in Chapter 5 to remove the computer's cover and subassembly. When you complete your drive installation or removal, follow the instructions in Chapter 5 to replace the subassembly and cover. Then see "Post-installation Setup Procedures" at the end of Chapter 6 for information about updating your drive configuration. Caution Installing or removing a disk drive is a complicated procedure, so you may want to ask your dealer to do it for you. If you decide to do it yourself, you must carefully follow all the instructions in this chapter or you could damage your equipment. Installing and Removing Disk Drives 7-1