Epson Equity 320SX PLUS User Manual - Page 190

7. If your computer still does not respond, you can reset it using the Ctrl Alt Del command or the RESET button. See "Resetting Your Computer" in Chapter 3 for more information. 8. If resetting the computer does not work, turn it off and wait at least five seconds. If you do not have a hard disk drive, insert the Startup or Reference diskette in drive A. Then turn on the computer. It should load MS-DOS. 9. If you installed a display adapter card in your computer, and you want to use that adapter as your primary display adapter, you need to change the setting of jumper Jl on the main system board to disable the built-in VGA adapter. If you have not set the jumper, you will not see any display on the screen. You may also need to set jumpers J3 and J5. See "Changing the Jumper Settings" in Chapter 6 for instructions. Password Problems If you set a password using the SETUP program, you must enter it before you can use the system. When you turn on the computer, it runs a memory test. Then the screen displays the Enter Password prompt. If you do not enter the correct password, you cannot use the computer. If you have any trouble using your password, try the following: P If you type the password and press Enter but nothing happens, type it again and press Enter. Cl If you know the current password but you want to change or delete it, see Chapter 2 for instructions. 0 If you do not know the current password, follow the steps below. Troubleshooting C-5