Epson FastFoto FF-680W Users Guide - Page 29

If thicker paper does not eject properly or falls from the output tray, push in the output tray

Page 29 highlights

Note: If you are scanning a photo that is longer than 12.1 inches (307.3 mm), support the photo as it enters into and ejects from the scanner as shown. 6. If necessary during scanning, adjust the position of the stopper and the output tray extension to fit the ejected photos. Note: If thicker paper does not eject properly or falls from the output tray, push in the output tray and allow the photos to eject freely onto the surface below the scanner. If the scanned images are affected by the photos ejecting below the scanner, try placing the scanner on the edge of a table where the ejected photos can drop freely. 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120

29
Note:
If you are scanning a photo that is longer than 12.1 inches (307.3 mm), support the photo as it
enters into and ejects from the scanner as shown.
6.
If necessary during scanning, adjust the position of the stopper and the output tray extension to fit
the ejected photos.
Note:
If thicker paper does not eject properly or falls from the output tray, push in the output tray and
allow the photos to eject freely onto the surface below the scanner. If the scanned images are
affected by the photos ejecting below the scanner, try placing the scanner on the edge of a table
where the ejected photos can drop freely.