Epson MovieMate 30s Quick Reference Guide - (Accolade Wireless Audio Set ) - Page 13
Connecting the Audio Set Receiver, Attaching the Antenna
View all Epson MovieMate 30s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Connecting the Audio Set Receiver Before you begin, make sure that your audio system is turned off. Then follow the steps in these sections on: ■ "Attaching the Antenna" below ■ "Powering the Receiver" on page 14 ■ "Connecting the Receiver's Audio Cable" on page 14 Attaching the Antenna 1. Remove the red cap from the receiver's antenna connector. 2. Attach one of the included antennas to the receiver, then hand-tighten the nut at the base of the antenna. Caution: Do not use a tool to tighten the nut, or you may damage the receiver. 3. If necessary, rotate the antenna so that it is facing upwards. When you're finished attaching the antenna, see "Powering the Receiver" on page 14. Connecting the Audio Set Receiver 13
Connecting the Audio Set Receiver
13
Connecting the Audio Set Receiver
Before you begin, make sure that your audio system is turned off. Then follow the
steps in these sections on:
■
“Attaching the Antenna” below
■
“Powering the Receiver” on page 14
■
“Connecting the Receiver’s Audio Cable” on page 14
Attaching the Antenna
1.
Remove the red cap from the receiver’s antenna connector.
2.
Attach one of the included antennas to the receiver, then hand-tighten the nut
at the base of the antenna.
Caution:
Do not use a tool to tighten the nut, or you may damage the receiver.
3.
If necessary, rotate the antenna so that it is facing upwards.
When you’re finished attaching the antenna, see “Powering the Receiver” on
page 14.