Epson PhotoPC 750Z Product Information Guide - Page 4

EPSON PhotoPC 750Z Minimum System Requirements Processor Operating System RAM Ports Display Hard drive space CD-ROM drive Windows® 486 or higher Windows 95, Windows 98, Windows NT® 3.51 or Windows NT 4.0 (Service Pack 3) At least 16MB Serial port with standard RS-232C interface (19,200 bps, or higher) 640 × 480, 256 colors At least 40MB Macintosh Power PC™ or higher processor System Software Version 7.1 or later (System 7.5 or later required to access CompactFlash card memory directly from the Macintosh) At least 16MB Standard Macintosh modem/printer port (19,200 bps, or higher) 640 × 480, 256 colors At least 40MB Double-speed Double-speed Using Batteries PhotoPC 750Z comes with four rechargeable NiMH batteries and a charger. Charging Batteries It's important to make sure your batteries are fully charged, so they will last as long as possible before they need recharging. Warning: Shock hazard. Make sure you use the charger only with EPSON rechargeable NiMH batteries (model EU-24). To avoid the danger of leakage or explosion, do not place any other batteries in the charger. Read all safety and handling instructions before using the charger. Note the following when charging batteries: t Do not insert batteries backwards. t Do not open the cover while batteries are charging. t Do not use near water or handle with wet hands. For indoor use only. t Do not use within reach of children. t Do not charge the batteries using an electrical outlet on an airplane. ++ + + Follow these steps to charge your batteries for the first time: 1. Lift up the cover of the charger and insert all four batteries, positioning the + and - ends as shown. Then close the cover firmly. 2. Turn the charger over and flip the two prongs out of their compartment. 3. Plug the charger into an electrical outlet. Both lights turn red, indicating that the charger is working. When the batteries are fully charged, after about two and a half hours, the lights go off. Note: The charger lights flash to indicate changes in battery temperature and voltage. If the lights continue to flash for more than half an hour, the batteries may be damaged or worn out, and should be replaced. Unplug the charger if the batteries are not fully charged after four hours. 4. Now charge your batteries again by opening and then closing the charger. The second charge should take about two and a half hours. 5. Charge the batteries a third time by opening and closing the charger again. This charge should take about 20 minutes. 4 - EPSON PhotoPC 750Z 1/99