Epson PhotoPC 750Z Product Information Guide - Page 5

Installing Batteries, EPSON PhotoPC 750Z - camera

Page 5 highlights

EPSON PhotoPC 750Z 6. After you have charged the batteries three times and both lights are off, unplug the charger. To avoid overcharging, don't leave the charger plugged in for long periods of time after the lights go off. 7. Wait one hour until the batteries cool before removing them from the charger. 8. Before storing the charger, press down on the prongs to lock the plug into place. (For subsequent charges of your NiMH rechargeable batteries, follow steps 1 through 3, then unplug your charger and follow steps 7 and 8 above.) Be sure to always charge the batteries completely to make them last as long as possible. They can be recharged hundreds of times, so do not dispose of them until they are worn out. Note: Keep the charger terminals clean by wiping them with a dry cloth. Make sure you charge all four batteries before you use them. If you find that your batteries run out faster after you recharge them a few times, make sure you discharge them completely before recharging. If this doesn't help, replace the batteries. Installing Batteries Before you install the batteries, make sure the camera dial is turned Off. Then follow these steps: 1. Turn the camera upside down with the LCD screen facing away from you. 2. Slide the battery cover lock from Lock to Open. 3. Lift the cover up and away from the camera. 4. Insert all four batteries into the compartment, positioning the + and - ends as shown: 5. Close the battery cover and hold it down while sliding the battery cover lock from Open to Lock. Handling Batteries If you forget to charge your NiMH rechargeable batteries or they need to be replaced, the camera can also accept the following: t Rechargeable AA NiCad batteries t Single-use AA alkaline batteries (Panasonic® brand recommended) t Single-use AA lithium batteries (longer life) Energizer® brand recommended Warning: To avoid the danger of fire or explosion, do not mix different types of batteries. Replace all four batteries at the same time. Do not allow the battery contacts to touch metal objects such as coins or keys, which could short out the battery's circuits. Charge your NiMH batteries only with the EPSON NiMH battery charger (Model EU-24). Do not put in fire or water, drop or apply pressure, disassemble, short-circuit, or apply heat. Keep away from small children. If battery acid gets into your eyes or on your skin, immediately rinse the affected area well with water and seek medical treatment. If a battery is swallowed, seek medical treatment immediately. 1/99 EPSON PhotoPC 750Z - 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10

EPSON PhotoPC 750Z
1/99
EPSON PhotoPC 750Z
- 5
6.
After you have charged the batteries three times and both
lights are off, unplug the charger. To avoid overcharging,
don’t leave the charger plugged in for long periods of time
after the lights go off.
7.
Wait one hour until the batteries cool before removing
them from the charger.
8.
Before storing the charger, press down on the prongs to lock
the plug into place.
(For subsequent charges of your NiMH rechargeable batteries,
follow steps 1 through 3, then unplug your charger and follow
steps 7 and 8 above.)
Be sure to always charge the batteries completely to make
them last as long as possible. They can be recharged hundreds
of times, so do not dispose of them until they are worn out.
Note:
Keep the charger terminals clean by wiping them with a dry cloth.
Make sure you charge all four batteries before you use them. If you
find that your batteries run out faster after you recharge them a few
times, make sure you discharge them completely before recharging.
If this doesn’t help, replace the batteries.
Installing Batteries
Before you install the batteries, make sure the camera dial is
turned
Off
. Then follow these steps:
1.
Turn the camera upside down with the LCD screen facing
away from you.
2.
Slide the battery cover lock from
Lock
to
Open
.
3.
Lift the cover up and away from the camera.
4.
Insert all four batteries into the compartment, positioning
the + and – ends as shown:
5.
Close the battery cover and hold it down while sliding the
battery cover lock from
Open
to
Lock
.
Handling Batteries
If you forget to charge your NiMH rechargeable batteries or
they need to be replaced, the camera can also accept the
following:
Rechargeable AA NiCad batteries
Single-use AA alkaline batteries (Panasonic
®
brand
recommended)
Single-use AA lithium batteries (longer life) Energizer
®
brand recommended
Warning:
To avoid the danger of fire or explosion, do not mix different types of
batteries. Replace all four batteries at the same time. Do not allow
the battery contacts to touch metal objects such as coins or keys,
which could short out the battery’s circuits. Charge your NiMH
batteries only with the EPSON NiMH battery charger (Model EU-24).
Do not put in fire or water, drop or apply pressure, disassemble,
short-circuit, or apply heat. Keep away from small children. If battery
acid gets into your eyes or on your skin, immediately rinse the
affected area well with water and seek medical treatment. If a battery
is swallowed, seek medical treatment immediately.