Epson PhotoPC L-410 Product Information Guide - Page 4

Epson PhotoPC L-410 3. Make sure you are at least 20 inches (50 cm) away from your subject. ❏ To zoom in on your subject, press the T (telephoto) button. ❏ To zoom out, press the W (wide-angle) button. 4. Center your subject in the middle of the square focus frame on the screen. The default flash setting is automatic, indicated by the icon on the LCD screen. The flash will go off automatically whenever necessary. If you want to change the flash setting, press the r button. See the list of flash settings in the next column. 5. Press and hold the shutter button halfway. The focus frame turns green and the focus is set. If you want to reframe your picture, move the camera until the photo you want appears on the screen. 6. Press the shutter button all the way down. The camera beeps as it captures the image. Note: The LCD screen may turn off to save battery power after you take a picture. Press any button or turn the Mode dial to turn the screen back on. Camera Settings Camera settings are displayed on the LCD screen. Press the DISP button to turn the display on or off. Settings and Icons Self-timer (2 seconds), (10 seconds) Focus frame Place your subject within the focus frame. When you press the shutter button halfway, the focus frame turns green. Battery life Displays for a few seconds to indicate battery is full, half-full, or empty Zoom bar The digital zoom indicator appears when W or T is pressed. Scene mode Landscape mode, Portrait mode Exposure compensation (+2.0 to -2.0) Sensitivity (Auto, 100, 200, 400) White balance (Auto, Daylight, Cloudy, Incandescent, Fluorescent, Mercury) Quality F2304, F1600, F640, N1600, N640 N2304, Macro mode Macro Flash Auto-flash, Flash off, Auto red-eye reduction, Fill-in flash, Slow synchro Shooting mode Continuous shooting mode, Video mode Photos left 125 (for example) Warning Camera shake Taking Photos With Fun Frames You can use P.I.F. (PRINT Image Framer®) to take pictures with a variety of frames for holidays and special occasions. Frames are already stored in your camera, and additional frames are copied to your computer when you install the camera software. You can use the PRINT Image Framer Tool to copy the frames from your computer to the camera. You can also modify the frames or create original frames using PIF Designer. See the Camera Basics manual for instructions on installing the software. 8/04 Epson PhotoPC L-410 - 4