Epson PowerLite 71c Product Information Guide - Page 12
Replacing the Lamp, Warning, Caution - powerlite 51c 71c projector
View all Epson PowerLite 71c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
EPSON Powerlite 51c/71c Follow these steps to clean the vent: 1. Turn off the projector, let it cool down, and unplug the power cord. 2. Stand the projector on its back panel with the lens pointing upward. Warning: Let the lamp cool before replacing it. To avoid premature lamp failure, do not touch the glass portion of the lamp assembly. 3. Turn the projector upsidedown to access the lamp compartment. 4. To remove the lamp cover, press on the two tabs and pull out the cover. 3. To clean the vent, EPSON recommends using a small vacuum cleaner designed for computers and other office equipment. If you don't have one, use a dry, lint-free cloth. If the dirt is difficult to remove, you may need to have the air intake vent replaced. Use the EPSON PrivateLine® Support Service to obtain the name of the EPSON Customer Care Center nearest to you. Call (800) 637-7661 and enter the PIN on the card in your Owner's Kit. If you can't find your card, dial (562) 276-4394 (U.S.) or (905) 709-3839 (Canada). Toll or long distances charges may apply. 5. Use a screwdriver to loosen the two lamp cover screws; you can't remove the screws. Then pull out the lamp by the two notches. 6. Position the new lamp correctly, then gently insert it into the projector. Press it into place and tighten the retaining screws. Replacing the Lamp The projection lamp typically lasts for about 1500 hours of use. It is time to replace the lamp when: ❏ The projected image gets darker or starts to deteriorate. ❏ The Error light on top of the projector is flashing red in 1-second intervals. ❏ The LAMP REPLACE message appears on the screen when the projector lamp comes on (after about 1500 hours of use). To maintain projector brightness and image quality, replace the lamp as soon as possible after you see the message. Note: To view the number of hours your lamp has been used, check the About menu. Request replacement lamp part number V13H010L16. Follow these steps to replace the lamp: 1. Turn off the projector, let it cool down, and unplug the power cord. 2. Allow the projector to continue cooling for at least one hour (if it has been on). 7. Insert the lamp cover as shown and press it back into place. Caution: Make sure the lamp cover is securely fastened; the Error light flashes and the projector lamp won't turn on if the cover is open. 8. Follow the instructions on page 11 to access the projector's About menu and reset the lamp counter to zero. 12 - EPSON Powerlite 51c/71c 12/01