Epson PowerLite Pro Cinema 9700 UB User's Guide - Page 20

Making Other Connections, be used to operate a motorized anamorphic lens. - pro cinema ub

Get Epson PowerLite Pro Cinema 9700 UB - PowerLite Pro Cinema 9700UB Projector PDF manuals and user guides View all Epson PowerLite Pro Cinema 9700 UB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Making Other Connections Connect the power cable and other cables described below, depending on how you plan to use the projector. ■ Plug the power cable into the projector and a grounded electrical outlet. ■ The Trigger out port outputs a 12-volt DC signal when the projector is turned on. This lets a central control system monitor whether the projector is on or off, and can be used to raise or lower your projection screen automatically when the projector is in use. On the Pro Cinema 9700 UB, it can also be used to operate a motorized anamorphic lens. Connect a 3.5-mm mini jack to the port, as shown. Use the Trigger Out setting to enable the port (see page 48). ■ To use an AV controller with the projector, connect a 9-pin null modem serial cable to the RS-232C port. Refer to the table of ESC/VP21 command codes on page 69. 20 Setting Up the Projector

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
20
Setting Up the Projector
Making Other Connections
Connect the power cable and other cables described below, depending on how you plan to
use the projector.
■
Plug the power cable into the projector and a grounded electrical outlet.
■
The
Trigger out
port outputs a 12-volt DC signal
when the projector is turned on. This lets a central
control system monitor whether the projector is on
or off, and can be used to raise or lower your
projection screen automatically when the projector
is in use. On the Pro Cinema 9700 UB, it can also
be used to operate a motorized anamorphic lens.
Connect a 3.5-mm mini jack to the port, as shown.
Use the
Trigger Out
setting to enable the port (see
page 48).
■
To use an AV controller with the projector, connect a 9-pin null modem serial cable to
the
RS-232C
port. Refer to the table of ESC/VP21 command codes on page 69.