Epson Stylus C60 Product Information Guide - Page 6

EPSON Stylus C60 Replacing an Ink Cartridge To ensure good results, use genuine EPSON ink cartridges and don't refill them. Other products may cause damage to your printer not covered by EPSON's warranty. You cannot print if either cartridge is empty. Leave the empty cartridge installed until you have obtained a replacement. Otherwise, the remaining ink in the nozzles may dry out. Use these ink cartridges within six months of installing them and before the expiration date on the package: ❏ Black: T028201 ❏ Color: T029201 Low ink: red b error light flashes and a status screen appears telling you which cartridge is low. Empty cartridge: red b error light stays lit and the empty cartridge is indicated on the screen; you must replace it to continue printing. The red b error light also comes on if your paper runs out or is jammed, so make sure you check your paper before replacing a cartridge. 1. Open the printer cover and press the e ink replacement button. The print head moves to the center and the lights flash. 3. Remove the cartridge and dispose of it carefully. Keep cartridges out of the reach of children and do not drink the ink. If ink gets on your hands, wash them with soap and water. If it gets in your eyes, flush them immediately with water. 4. Unpack the new ink cartridge and remove the yellow tape. black cartridge color cartridge You must remove the yellow tape from the top of the cartridge or you will permanently damage it. Don't try to remove the clear seal underneath the cartridge. Don't touch the green circuit board on the back of the cartridge, or you may inhibit normal operation and printing. 5. Tilt the new cartridge toward you slightly as you insert it. Lower the cartridge so that the tabs rest on the hooks. hooks 2. Lift up the ink cartridge clamp. The cartridge rises up from its holder. . Don't place the cartridge tabs under the hooks; you may damage the clamp when you close it. 6 - EPSON Stylus C60 7/01