Epson SureColor P6000 Designer Edition User Manual - Page 181
LCD screen message, Condition/solution, Job Cancel, Manual, Auto Take-up Reel Unit
View all Epson SureColor P6000 Designer Edition manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 181 highlights
LCD screen message Condition/solution F/W Install Error The firmware updated did not install. Firmware update failed. Turn off the printer, wait for awhile, and turn on the printer again. Then run Restart the printer. the firmware update file again. If the message still appears, contact Epson for support. Command Error The printer driver sent an invalid or incorrect command to the printer. Check driver settings. Press the cancel button and select Job Cancel. Make sure that the driver you are using supports your product. Reel Unit Error Turn off the printer, wait for awhile, and turn on the printer again. Check Auto Take-up Reel Unit and restart printer. If the message still appears, contact Epson for support. Reel Unit Error Check Auto Take-up Reel Unit cable and restart printer. Reconnect the cable that runs from the optional Auto Take-up Reel and the printer. Reel Unit Disconnected Auto Take-up Reel Unit is disconnected. Do you continue? The optional Auto Take-up Reel is not connected. Reconnect the unit and select No on the control panel to turn the printer off. Wait a moment, then turn the printer on again. To continue printing without the Auto Take-up Reel, select Yes on the control panel. See the Auto Take-up Reel documentation for more details. Take-Up Error The optional Auto Take-up Reel cannot take up media. Is anything obstructing the take-up reel sensor system? Check the optional Auto Take-up Reel sensor and clear any obstructions, then press the OK button. If there is any loose paper on the Auto Take-up Reel roll core, set the Auto switch to Off and hold the Manual switch in the take-up direction to remove slack in the roll paper. Confirm that the paper is attached to the roll core correctly, then return the Auto switch to the original position and press the OK button. 181