Epson TM-T88IV TM-T88IV Technical Reference Guide - Page 43
Setting the Memory Switches, Selecting the print density
View all Epson TM-T88IV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Chapter 2 Setup Setting the Memory Switches With the "memory switch (customized value," which is a software switch of this printer, you can set: • Print density • Print speed • Number of head energizing parts • Single-color printing/two-color printing • Black-color density in two-color printing Use the Memory Switch Setting Utility or a command to set the memory switches. In power saving mode, all customized value settings are ignored. • For detailed information about the memory switch utility, see the user's manual for the Memory Switch Setting Utility. • For detailed information about ESC/POS commands, see the ESC/POS Application 2 Programing Guide. Selecting the print density Selectable from levels 1 to 13 (light ∼ dark). The print density can be set with DIP switches (2-3/2-4) or the customized value. (See "Setting the Memory Switches" on page 43.) The initial setting of the customized value is "Depends on the DIP switch settings." If the customized value is changed, the value set with the customized value is enabled. Selecting the print speed Selectable from levels 1 to 9 (low ∼ high). (Initial setting: level 9) Depending on print conditions such as print duty, print head temperature, or data transmission speed, print speed is automatically adjusted which may cause white lines due to intermittent print (the motor sometimes stops). To avoid this, keep the print speed constant by setting it lower, or set the transmission speed higher in case of the serial interface. (See "Transmission speed (DIP switch 1-7/1-8)" on page 36.) 43