Epson V11H128020 Product Information Guide - Page 13
Replacing the Air Filter, Replacing the Lamp
UPC - 010343847408
View all Epson V11H128020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
EPSON PowerLite S1 Projector 2. Turn the projector upside-down and use a small vacuum cleaner designed for computers and other office equipment. If you don't have one, use a dry, lint-free cloth. 4. Replace the air filter with a new one. Make sure there are no gaps between the air filter and the plastic grill. 5. Insert the air filter cover tabs, and then press down on the opposite side until it clicks into place. Note: If the air filter is difficult to clean or if it is broken, it should be replaced. See the next section for instructions. Spare lamps are provided with new air filters. When replacing the lamp, please replace the air filter at the same time. Replacing the Air Filter If you need to replace the air filter, you can obtain it in the following ways: ❏ Purchase one from your dealer ❏ Call EPSON at (800) 873-7766 or visit the EPSON StoreSM at www.epsonstore.com (U. S. sales only). In Canada, please call (800) 463-7766 for dealer referral. Note: If you are also replacing the lamp, you can use the new air filter that comes with it. Follow these steps to replace the air filter: 1. Turn off the projector and wait for it to cool down. 2. Disconnect the power cord. 3. Turn the projector upside-down. Push in the tab on the air filter cover and lift up the air filter cover to remove it. Replacing the Lamp The projection lamp typically lasts for about 2000 hours of use. It is time to replace the lamp when: ❏ The projected image gets darker or starts to deteriorate. ❏ The error light on top of the projector is flashing red in 0.5-second intervals. ❏ The message LAMP REPLACE appears on the screen when the projector lamp comes on (after about 1900 hours of use). To maintain projector brightness and image quality, replace the lamp as soon as possible after you see the message. Request replacement lamp part number V13H010125. Note: To view the number of hours your lamp has been used, check the About menu. Warning: Be extremely careful when removing the lamp module. Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to avoid injury. In the unlikely event that the bulb has ruptured, small glass fragments may be present and should be removed with caution. If your projector is mounted on the ceiling, you should unmount it before accessing the lamp compartment. This will make it easier for you to replace the lamp and minimize the chance of any small glass fragments dropping from the projector. 12 - EPSON PowerLite S1 Projector 5/03