Epson WorkForce Pro WF-C5790 Users Guide for Latin America - Page 405
in the wrong orientation may damage both devices connected by the cable.
View all Epson WorkForce Pro WF-C5790 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 405 highlights
ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating. • Always turn off the product using the power button, and wait until the power light stops flashing before unplugging the product or cutting off power to the electrical outlet. • If you will not be using the product for a long period, unplug the power cord from the electrical outlet. • Place the product on a flat, stable surface that extends beyond its base in all directions. It will not operate properly if it is tilted or at an angle. • Make sure the back of the product is at least 4 inches (10 cm) away from the wall. • Allow space behind the product for the cables, and space above the product so that you can fully raise the document cover. • Leave enough space in front of the product for the paper to be fully ejected. • Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations, or dust. • Do not place or store the product outdoors. • Do not place the product near excessive heat sources or in direct sunlight. • Leave enough room around the product for sufficient ventilation. Do not block or cover openings in the case or insert objects through the slots. • Keep the product away from potential sources of electromagnetic interference, such as loudspeakers or the base units of cordless telephones. • Keep your product at least 8.7 inches (22 cm) away from cardiac pacemakers to prevent your product's radio waves from affecting the operation of the pacemaker. • When connecting the product to a computer or other device with a cable, ensure the correct orientation of the connectors. Each connector has only one correct orientation. Inserting a connector in the wrong orientation may damage both devices connected by the cable. • Do not spill liquid on the product or use the product with wet hands. • Do not use aerosol products that contain flammable gases inside or around the product. Doing so may cause fire. • Do not press too hard on the document table when placing originals. • Do not open the scanner section while the product is copying, printing, scanning, or performing any other functions. • Be careful not to trap your fingers when closing the document cover or scanner. • Except as specifically explained in your documentation, do not attempt to service or disassemble the product yourself. 405