Fellowes 49C Manual - Page 3

BASIC SHREDDING OPERATION Continuous operation: 6Q
UP

NJOVUFT
NBYJNVN NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 5 minutes will trigger a 30-minute cool down period. PAPER/CARD 1 2 3 4 Plug in and put Set to Auto-On ( ) disconnect power switch in ON (I) position Feed paper/card straight into paper entry and release When finished shredding set to OFF ( ) Safety Lock prevents accidental operation. To set, wait for shredding to stop, push black button down and slide towards front of shredder. To unlock push black button down and slide toward back of shredder. For greater safety, always unplug shredder after use. PRODUCT MAINTENANCE OILING SHREDDER All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin. FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE 1 2 3 Set to Off ( ) *Apply oil across entry Set to Reverse ( ) for 2-3 seconds *Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250 TROUBLESHOOTING Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder. PAPER JAM 1 2 3 4 5 6 Set to Reverse ( ) for 2-3 seconds Alternate slowly back and forth Set to Off ( ) and unplug Gently pull uncut paper from paper entry. Plug in. Set to Auto-On ( ) and resume shredding LIMITED PRODUCT WARRANTY Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of incurred by Fellowes to provide parts or services outside of the country where the shredder is initially defects in material and workmanship and provides service and support for 1 year from the date of TPME
CZ
BO
BVUIPSJ[FE
SFTFMMFS
"/:
*.1-*&%
8"33"/5:
*/$-6%*/(
5)"5
0'
.&3$)"/5"#*-*5:
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free 03
'*5/&44
'03
"
1"35*$6-"3
163104&
*4
)&3&#:
-*.*5&%
*/
%63"5*0/
50
5)&
"113013*"5&
from defects in material and workmanship for 3 years from the date of purchase by the original WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential consumer. If any part is found to be defective during the warranty period, your sole and exclusive or incidental damages attributable to this product. This warranty gives you specific legal rights. remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This The duration, terms, and conditions of this warranty are valid worldwide, except where different warranty does not apply in cases of abuse, mishandling, failure to comply with product usage limitations, restrictions, or conditions may be required by local law. For more details or to obtain standards, shredder operation using an improper power supply (other than listed on the label), or service under this warranty, please contact us or your dealer. unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs 3