Fisher and Paykel DE27CW1 User Guide - Page 32

Level Machine, Final Installation Check List - heating element

Get Fisher and Paykel DE27CW1 PDF manuals and user guides View all Fisher and Paykel DE27CW1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Level Machine Check the dryer is level, and make necessary adjustments to the front levelling feet. The rear levelling feet are self adjusting. Final Installation Check List Check that: No plastic or flexible metal foil is used in the exhaust ducting. Exhaust is rigid ducting or thick wall flexible metal ducting. All joints in the ducting are made with duct tape. It must not be connected with screws or other fastening devices which extend into the inside of the duct. Ducting is clean and is connected to the dryer. Inserts are fitted to the two front feet. Dryer is level across the front. Additionally for Electric Dryer Models Only, Check: If installation is 208V, special element kit has been fitted (see page 23). Dryer is plugged or directly wired into an approved fitting and is properly grounded. Dryer starts, heats, cools and shuts off. Customer has been shown how to use the dryer. Additionally for Gas Dryer Models Only, Check: Dryer is plugged into an approved fitting and is properly grounded. All fittings in the gas line are tested for leaks. Exhaust temperature increases, to confirm ignition has occurred. - If ignition does not occur initially, it may be due to air in the gas line or low voltage power supply. - The gas regulator valve may fail to open if the power supply falls below 105 Volts. - If the gas fails to flow or does not ignite, the dryer will automatically switch off. Customer has been shown how to use the dryer. Note: All dryers have a drum reversal feature to reduce clothes tangle. Throughout the drying cycle the motor will run for four minutes, then stop and run in the opposite direction for forty seconds before reversing again. WARNING! Electric Shock Hazard Read and follow the Important safety instructions outlined in this User Guide before operating this appliance, pages 6 - 8. Failure to do so can result in death, electric shock, fire or injury to persons. Close supervision is necessary if this dryer is used by or near children. Do not allow children to play inside, around or with this dryer or any other appliance. 32

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
32
Level Machine
Check the dryer is level, and make necessary adjustments to the
front levelling feet. The rear levelling feet are self adjusting.
Final Installation Check List
Check that:
No plastic or flexible metal foil is used in the exhaust ducting.
Exhaust is rigid ducting or thick wall flexible metal ducting.
All joints in the ducting are made with duct tape. It must not be connected with screws or other
fastening devices which extend into the inside of the duct.
Ducting is clean and is connected to the dryer.
Inserts are fitted to the two front feet.
Dryer is level across the front.
Additionally for Electric Dryer Models Only, Check:
If installation is 208V, special element kit has been fitted (see page 23).
Dryer is plugged or directly wired into an approved fitting and is properly grounded.
Dryer starts, heats, cools and shuts off.
Customer has been shown how to use the dryer.
Additionally for Gas Dryer Models Only, Check:
Dryer is plugged into an approved fitting and is properly grounded.
All fittings in the gas line are tested for leaks.
Exhaust temperature increases, to confirm ignition has occurred.
– If ignition does not occur initially, it may be due to air in the gas line or low voltage power supply.
– The gas regulator valve may fail to open if the power supply falls below 105 Volts.
– If the gas fails to flow or does not ignite, the dryer will automatically switch off.
Customer has been shown how to use the dryer.
Note:
All dryers have a drum reversal feature to reduce clothes tangle. Throughout the drying cycle
the motor will run for four minutes, then stop and run in the opposite direction for forty seconds
before reversing again.
WARNING!
Electric Shock Hazard
Read and follow the Important safety instructions outlined in this User
Guide before operating this appliance, pages 6 – 8.
Failure to do so can result in death, electric shock, fire or injury to persons.
Close supervision is necessary if this dryer is used by or near children. Do not allow children to
play inside, around or with this dryer or any other appliance.