Fisher and Paykel RF135BDRUX1 Joiner Kit Instructions (English) - Page 4

Joiner Kit For Fisher & Paykel Models: C270, E249T, E240B, E210, E381T, E372B, N388, E388, C450, E450, E402B, E411T, E415H, E413T, E406B, E440T, E442B, E521T & E522B PREPARE FOR INSTALLATION Step1. 1. Check that the internal cupboard cavity dimensions are correct for the type of installation you require. 2. Unpack the refrigerator and freezer cabinets from their separate delivery cartons (see individual cartons for unpacking procedures). 3. Ensure the floor and/or the cupboards are protected from damage during the unpacking and assembly of the cabinets. 4. Check the refrigerator and freezer doors are hinged on the desired side. 5. Check that the Kit is complete (refer to Joiner Kit parts list on page 1). Note: due to the size of the refrigerator cabinets, it is essential that any assembly of the kit be undertaken with a minimum of two able-bodied persons. INSTALLATION PROCEDURE Step 2. If your refrigerator has a unit compartment cover at the back, remove using a Phillips type screw driver (USA market only). This will be re-attached later. Looking at the back of the two products, locate the Rear Bracket onto the rear bottom left hand edge of the right hand side product. Care must be taken to line up the top edge of the Rear Bracket with the bottom edge of the white back panel. Secure the Rear Bracket with 3 of the screws (Type A, self tapping, silver). These 3 screws are mounted from the side. Please note there are no pre-drilled holes for these screws which hold the rear bracket onto the side of the cabinet. Right hand side cabinet Do not secure with screws (see page 4). Left hand side cabinet Right hand side cabinet Step 3 Step 4. Locate the front adjustable feet. One can be found at each of the cabinet's front lower corners. Adjust the two feet by turning either clockwise or anti-clockwise until the two cabinets are level. Step 4 Step 5. Remove the three screw hole caps from the top surface of each of the cabinets with a small flat bladed screwdriver by gently prising them loose. The caps can be found on the front edge of the top surface of the cabinets, opposite side to the hinge. Ensure that the top panel is not scratched or deformed during this process. The total of six screw hole caps are not required to be used with the kit. Step 2 Step 3. Locate the left hand side cabinet's bottom right rear wall within the open "U" section in the rear bracket. Ensure that the cabinet sits firmly with the rear bracket. Step 5 Introduction Date: October 2007 Pt No.819265 INSTRUCTION KIT JOINER RF 4