Fisher and Paykel RF135BDRUX1 Joiner Kit Instructions (English) - Page 6

Joiner Kit For Fisher & Paykel Models: C270, E249T, E240B, E210, E381T, E372B, N388, E388, C450, E450, E402B, E411T, E415H, E413T, E406B, E440T, E442B, E521T & E522B The Front Lower Bracket is now located on the underside of the Cabinets. Care must be taken to orient the bracket so that the two small tabs are located with the slots on the underside of the Cabinet. Step 10 The two Leveling Feet Mounting Bolts are firmly located back onto the cabinet, securing the Front Lower Bracket. The two Leveling Feet are now screwed back into their existing position. Once assembled, lower the Refrigerator assembly back to a standing position, taking care not to damage it or the surrounding cupboards/floor. Step 12 Open both the cabinet doors for easy access to the center join of the two Cabinets. Step 10 Step 11 Before loading the Trim Panel Assembly, The six Type B Screws must be loosened from the Front Top Bracket, so that the bracket can be freely moved up and down (approximately 5mm/1/8"). Step 12 Step 13 If using kit on shorter models, cut Trim Panel Assembly (Extrusion cover & Extrusion support) to length shown in table below. Model Trim Height (mm / inches) C270, E249T, E240B, E210, E381T, E372B, E413T, E406B 1562 / 61 ½ N388, E388, C450, E450, E402B, E411T, E415H, E440T, E442B, E521T, E522B 1662 / 65 ½ (Standard Height) Locate the Trim Panel Assembly on the upright tab that protrudes from the Front Lower Bracket. Step 11 Step 13 Introduction Date: October 2007 Pt No.819265 INSTRUCTION KIT JOINER RF 6