Fluke 718-300G Fluke 718 Users Manual - Page 12

Series, Instruction Sheet, Table 2. Safety Information cont. - specifications

Get Fluke 718-300G PDF manuals and user guides View all Fluke 718-300G manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

718 Series Users Manual Table 2. Safety Information (cont.) XW Warning • To avoid false readings, which could lead to possible electric shock or personal injury, replace the battery as soon as the battery indicator B appears. • To avoid a violent release of pressure in a pressurized system, shut off the valve and slowly bleed off the pressure before you attach or detach the internal pressure sensor or pressure module fitting to the pressure line. • To avoid over pressure damages, do not apply pressure that exceeds the limits listed in the Pressure Specifications table in the "Specifications" section. • To avoid mechanically damaging the Calibrator, do not apply torque between the pressure fitting and the Calibrator case. See Figure 1 for the proper use of tools. • To avoid misleading readings, disconnect the pressure module connector at the Calibrator. • To avoid damage to the pressure module, refer to the related Instruction Sheet. • To avoid damage to the pump, use with dry air and non-corrosive gases only. Check test leads for continuity before using. Inspect Calibrator for cracks or damage, do not use the probes if they are damaged or show high resistance. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
718 Series
Users Manual
4
Table 2. Safety Information (cont.)
XW
Warning
•
To avoid false readings, which could lead to possible electric shock or personal injury, replace the
battery as soon as the battery indicator
B
appears.
•
To avoid a violent release of pressure in a pressurized system, shut off the valve and slowly bleed off
the pressure before you attach or detach the internal pressure sensor or pressure module fitting to the
pressure line.
•
To avoid over pressure damages, do not apply pressure that exceeds the limits listed in the Pressure
Specifications table in the “Specifications” section.
•
To avoid mechanically damaging the Calibrator, do not apply torque between the pressure fitting and
the Calibrator case. See Figure 1 for the proper use of tools.
•
To avoid misleading readings, disconnect the pressure module connector at the Calibrator.
•
To avoid damage to the pressure module, refer to the related
Instruction Sheet
.
•
To avoid damage to the pump, use with dry air and non-corrosive gases only. Check test leads for
continuity before using. Inspect Calibrator for cracks or damage, do not use the probes if they are
damaged or show high resistance.