Foxconn G31MV-K English Manual. - Page 38

Advanced BIOS Features Phoenix - AwardBIOS CMOS Setup Utility Advanced BIOS Features ► Removable Device Priority ► Hard Disk Boot Priority CPU L1 & L2 Cache First Boot Device Second Boot Device Third Boot Device Boot Other Device Boot Up Floppy Seek Boot Up NumLock Status Security Option x APIC Mode Delay For HDD (Seconds) Full Screen Logo Show [Press Enter] Item Help [Press Enter] [Enabled] Menu Level ► [Hard Disk] Select Removable Boot [CDROM] Device Priorty [Removable] [Enabled] [Disabled] [On] [Setup] Enabled [ 2] [Enabled] 3 Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help F5: Previous Values F7: Optimized Defaults ► Removable Device Priority This option is used to select the priority for removable device. ► Hard Disk Boot Priority This option is used to select the priority for HDD startup. After pressing , you can select the HDD using the Up/Down arrow keys, and change the HDD priority using / ; you can exit this menu by pressing . ► CPU L1 & L2 Cache Enable/Disable CPU cache setting. L1, L2 cache are small, fast memory caches that are built into a CPU and help speed access to important and frequently-used data. L1 cache is typically smaller and faster than L2 cache. L1 cache is an abbreviation of Level 1 cache. ► First/Second/Third Boot Device These three options allow you to select the priority of boot sequence from different devices. ► Boot Other Device With this function set to enable, the system will boot from some other devices provided that the first/second/third boot devices failed. The options are: Disabled and Enabled. ► Boot Up Floppy Seek This item controls whether the BIOS will be checking for a floppy drive while booting up. If it cannot detect one (either due to improper configuration or physical unavailability), it will appear an error message. Disabling this function, then POST will not detect the floppy. ► Boot Up NumLock Status This item defines if the keyboard Num Lock key is active when your system is started. The available settings are: On (default) and Off. ► Security Option When it is set to "Setup", a password is required to enter the CMOS Setup screen; When it is set to "System", a password is required not only to enter CMOS Setup, but also to start up your PC. ► APIC Mode (Advanced Programmable Interrupt Controller) This item is used to enable or disable APIC function. 31