Frigidaire FAS255P2A Use and Care Manual - Page 9
Heating Feature, You Will See, Light On, Clean Air Feature, Remote Sensing Feature
View all Frigidaire FAS255P2A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Air Conditioner Features (continued) HEATING FEATURE(on some models): Temp /Timer YOU WILL SEE: Temp /Timer Fan Slower Fan Slower Fan Faster Fan Faster AUTO Auto Cool Clean Air Heat Fan Energy Saver Cool Mode Temp /Timer Timer Sleep Check Filter Remote Sensing On/Off DO THIS: PRESS MODE BUTTON SELECT HEAT LIGHT ON AUTO Auto Cool Clean Air Heat Fan Energy Saver Cool Mode Temp /Timer Timer Sleep Check Filter Remote Sensing On/Off NOTE: This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the Heat Mode, the fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between 60 F(15 ) and 90 F(32 ). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room air. CLEAN AIR FEATURE(on some models): Temp /Timer YOU WILL SEE: Temp /Timer Fan Slower Fan Slower Fan Faster Fan Faster AUTO Auto Cool Clean Air Heat Fan Energy Saver Cool Mode Temp /Timer Timer Sleep Check Filter Remote Sensing On/Off DO THIS: PRESS CLEAN AIR BUTTON REMOTE SENSING FEATURE (on some models): LIGHT ON AUTO Auto Cool Clean Air Heat Fan Energy Saver Cool Mode Temp /Timer Timer Sleep Check Filter Remote Sensing On/Off NOTE: When this feature is "ON", the electronic air purifier is energized to remove pollen and impurities from the air. To cancel this feature, press the Clean Air button (the LIGHT will turn off). NOTE: This feature can be activated on the unit control panel ONLY. YOU WILL SEE: Temp /Timer Fan Slower Fan Faster AUTO Auto Cool Clean Air Sleep Check Filter Heat Fan Energy Saver Cool Mode Temp /Timer Timer Remote Sensing On/Off LIGHT ON DO THIS: PRESS REMOTE SENSING BUTTON ON NOTE: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode. To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing button. Next, use the buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself). The LIGHT on the remote control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal. It will continue to send this signal until the feature is deactivated by pressing the remote sensing button. If the unit does not receive the remote sensing signal during any 3 minute interval, The unit will beep to indicate the remote sensing mode has ended. The display on the remote control indicates the temperature at the remote ONLY. 9