Frigidaire FGB24S5DC Installation Instructions (All Languages) - Page 3

GAS WALL OVEN INSTALLATION INSTRUCTIONS 2. Connect Electricity to Gas Wall Oven For personal safety, these appliances must be properly grounded. This appliance is equipped with a three- prong grounding plug for your protection against shock hazard and must be plugged directly into a properly grounded receptacle. Do not cut or remove grounding prong from this plug. The wall receptacle and circuit should be checked by a qualified electrician to make sure the receptacle is properly grounded. Preferred Method Grounding type wall receptacle Do not, under any circumstances, cut, remove, or bypass the grounding prong. Power supply cord with 3-prong grounding plug Figure 2 Where a standard 2-prong wall receptacle is installed, it is the personal responsibility and obligation of the consumer to have it replaced by a properly grounded 3prong wall receptacle. Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. 3. Alternate construction (Model with 1½ oven cavity only) Installation Instructions for installing a 1½ cavity oven into an existing 2 cavity opening with dimensions 42 1/8" height by 22 ½" Width. 42 1/8" 22 ½" 2" 3" 1" Figure 3 1. Height adjuster - lower height adjuster 1". 2. If width opening is too wide to secure unit to cabinet with mounting screws, add filler strips. 3. 2" X 4" (standard 1 ½" X 3 ½") 22" minimum - stand upright and flush with front cabinet. Secure to floor or wall. 4. Lower trim (not shown) - overlap cabinet front (at bottom of cutout ¼" minimum. If an external electrical source is used, the appliance, when installed, must be electrically grounded in accordance with local codes or in their absence of local codes with the National Electric Code ANSI/NFPA No. 70-1987 or latest edition. Check all code rules and regulations for connecting the wall oven to be certain the installation conforms with all local, municipal and state codes as well as local utility regulations. Failure to comply with the above could result in a serious shock hazard. Note: All hookups and adjustments shall be performed by qualified technicians. Disconnect electrical supply cord from wall receptacle before servicing wall oven. 3