Frigidaire FGB24S5DC Installation Instructions (All Languages) - Page 6

GAS WALL OVEN INSTALLATION INSTRUCTIONS 8. Connection to gas A. Model with 1 ½ oven cavity (see figure 9) Pressure Regulator Shut-Off Valve 3/8" Nipple Adaptor or Union Solid Pipe Or Flex Connector External Shut-Off Valve Figure 9 If flexible gas connector is used, gas line must be A.G.A. design certified. B. Model with 2 oven cavities (see figure 10) Pilot Adjustment (If Equipped) Pressure Regulator Shut Off Valve Oven Safety Valve Shut Off Valve Support Bracket 3/8" Nipple Adaptor or Union External Shut Off Valve * Figure 10 IMPORTANT: Prior to attaching gas piping to the oven, move the shut-off valve support bracket to the left as far as possible and tighten its mounting screw from underneath the oven. This keeps the safety valve/ pressure regulator assembly from moving. BEFORE CONNECTING THE UNIT Remove all packing material and literature from wall oven before connecting gas and electrical supply to the appliance. If applicable, remove broiler or storage drawer by pulling drawer out to stops. Lift drawer front to clear stops and pull out. Leak testing of the appliance shall be conducted according to the manufacturer's instructions. Check for leaks. After connecting gas, check system for leaks with a manometer. If a manometer is not available shut all pilots off, turn the gas supply on the unit and use a liquid leak detector at all joints and connections. Tighten all connections if necessary to prevent gas leakage in the wall oven or supply line. IMPORTANT: A pipe joint sealant resistant to the action of LP Gas must be used on all pipe connections. Do not use a flame to check for leaks from gas connections. Checking for leaks with a flame may result in a fire or explosion. Disconnect the oven and its individual shutoff valve from the gas supply piping system during any pressure test greater than ½ psig. Isolate the wall oven from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psig. 9. LP/Propane Gas Conversion A. Pressure Regulator Conversion Note: Do not remove the Pressure Regulator. Convert the Pressure Regulator for use with LP Gas (see figure 11) If applicable, remove broiler or storage drawer by pulling drawer out to stops. Lift drawer front to clear stops and pull out. Locate pressure regulator on lower back wall and convert as shown in figure 11. A. Remove the cap from the pressure regulator. B. Remove the plunger. C. Turn the plunger upside down with the enlarge end TOWARDS regulator. D. Replace the plunger inside the regulator. The letters LP or 10" W.C. should be visible on the exposed end of the plunger. E. Replace the cap on the pressure regulator. NOTE: The type of gas pressure the regulator is set for is indicated on the top of the plunger. 6