Frigidaire GAH12ER2T Installation Instructions - Page 5

Wall Sleeve Brands: #4 General Electric/Hotpoint 167⁄8"Deep Rear Louvers 60° 1. Redirect the louvers at the back of the wall sleeve as shown in the 111" 01⁄2" illustration. The use of pliers is recommended. 60° Top View 3 ← 101⁄2"‹ → 2. Cut (2) 17"Tapered Spacer Blocks to 13" and install as shown in the illustration with the tapered end 1⁄2"from the back of the sleeve. 3 ← 61⁄2"‹→ 2 4 3 17" 3/4" Tapered Spacer Block 1" Cut Here ← 61⁄2"‹→ 13" Protection Paper Backing 3. Cut (1) 11⁄2"x 3/8"x 261⁄2"long seals to 25"long attach as shown. Attach (2) 11⁄2"x 3/8"x 14"long seals as shown in the illustration. 4. Attach 1"x 3/4"x 14"long seal to the louvered panel as shown in the illustration. 5. Install the new unit into the wall sleeve. Attach the ground wire to the unit as shown. 5 6. Install the 1"x 11⁄2"x 84"long stuffer seal between the wall sleeve and the unit. A flat bladed screwdriver or putty knife is recommended. 6 6 7. Assemble and install the Trim Frame. (see Trim Frame) 5