Fujitsu S500M Getting Started Guide - Page 7

1. Preparation This chapter describes necessary preparations before using ScanSnap. ATTENTION Do not connect the scanner to your personal computer before installing "ScanSnap Manager." If you connect the scanner before installing ScanSnap Manager, it will not operate correctly. Refer to Chapter 2 for details on the installation of ScanSnap Manager. „ Buttons 1.1. Checking the Contents of the Package When you unpack the scanner package, make sure that all parts are included. Refer to the packing list included in the scanner package for contents. 1.2. Name and Function of Parts This section describes the name and function of parts. „ Front Side „ Back Side USB connector [SCAN] button Start scanning. [POWER] button Hold down 1 sec. to turn on/off the power supply. Power lamp Indicate the scanner status. Blue: Ready Blue (Blinking): Scanning Orange: Error Light out: Power off AC adapter connector Paper chute Open the paper chute to use the scanner. Ö Opening the paper chute turns ON the scanner. Paper chute Open the paper chute and load documents onto it for scanning documents. Side guide Adjust these guides to fit the width of the paper, so that the paper does not skew. Cover open lever Pull this lever to open the ADF. ADF (ADF: Automatic Document Feeder) HINT ATTENTION Seal: After installing ScanSnap Manager onto your computer, remove this seal to connect the scanner to the PC. For the Document Specifications, refer to the "ScanSnap S500M Operator's Guide" stored in ScanSnap Setup CD-ROM. The scanner turns on/off automatically when you open/close the Paper chute. To turn off the scanner with the cover opened, press the [POWER] button. Stacker Extend this part to use the stacker Buttons as shown in the figure. Ö Sheets of paper are ejected from the ADF onto the stacker. * You can also use the scanner without the Stacker. ScanSnap S500M for Macintosh Getting Started | 5