Fujitsu XG1200 User Guide - Page 226

XG1200 User's Guide Message ID Severity S0116 ERROR Message/Explanation/Solution %1$ is not ready. Explanation It has been detected that XENPAK was installed, but XENPAK is disabled. [[Inserted string]]%1$: Number assigned to the port that failed to be ready correctly. S0117 ERROR Solution Check XENPAK connection. If the same message is displayed after taking an appropriate action, note the message contents and contact your XG1200 sales representative. port %1$ LASI RX Alarm is detected. (%2$) Explanation An XENPAK error has been detected. [[Inserted string]]%1$: Number assigned to the port that detected the error. [[Inserted string]]%2$: Displays additional information on the error. S0118 ERROR Solution Check XENPAK connection. If the same message is displayed after taking an appropriate action, note the message contents and contact your XG1200 sales representative. port %1$ LASI TX Alarm is detected. (%2$) Explanation An XENPAK error has been detected. [[Inserted string]]%1$: Number assigned to the port that detected the error. [[Inserted string]]%2$: Displays additional information on the error. Solution Remove and reinsert the XENPAK before checking its connection. If the same message is displayed after taking an appropriate action, note the message contents and contact your XG1200 sales representative. A.2.2 kernel (Basic XG1200 Control: 1000-1999) Message ID Severity S1000 CRITICAL Message/Explanation/Solution Abnormal reset occurred (WatchDog Reset: code=%1$) Explanation The fault monitor control detected an error and rebooted the XG1200. [[Inserted string]]%1$: Additional information that indicates the cause of reset. S1001 CRITICAL Solution Obtain maintenance information using the "tftp put-maintanace" command after restarting the system and then take a note of the message content before contacting the XG1200 sales representative. MAC address in EEPROM is invalid. Explanation An error was occurred in the device that stores the XG1200's MAC address. P1100 INFO P1101 INFO S1900 CRITICAL Solution Note the message contents and contact your XG1200 sales representative. %1$: config: auto-negotiation on, %2$ Explanation Management LAN auto-negotiation is being performed. [[Inserted string]]%1$: Name of target network interface [[Inserted string]]%2$: Displays supported features (speed and duplex). %1$: status: link %2$ Explanation The link status of the managment LAN has changed. [[Inserted string]]%1$: Name of target network interface [[Inserted string]]%2$: Displays details of the current link state. Core dumped %1$ Explanation A critical firmware error was detected and process dump output. [[Inserted string]]%1$: Process number Solution Obtain maintenance information using the "tftp put-maintanace" command and then take a note of the message content before contacting the XG1200 sales representative. 226/258 All Rights Reserved, Copyright (C) PFU LIMITED 2005