Fujitsu fi-5530C Getting Started Guide - Page 25

Appendix2 DAILY CARE WARNING When operating the scanner, the ADF's inside glass becomes very hot. Before you clean inside the scanner, turn off its power and unplug the AC adapter from the outlet. Wait for at least 15 minutes. Do not turn off the scanner when you clean the Feed rollers or Eject rollers. ■ Cleaning Materials Cleaning Materials Cleaner F1 Lint-free dry cloth Parts No. Remarks PA039500352 1 bottle Moisten a cloth with this fluid and wipe the scanner clean. - Commercially available one For details about the cleaning materials, contact the FUJITSU scanner dealer where you purchased the scanner. ■ Cleaning Method The ADF must be cleaned with a lint-free cloth moistened with the Cleaner F1. ATTENTION It may take long before the cleaner vaporizes if a large quantity is used. When cleaning the scanner parts, dampen a cloth with modest quantities of the cleaner. In addition, wipe off the cleaner completely with a soft lint-free cloth to leave no residue on the surface of the cleaned parts. ■ Locations and Cycle for Cleaning Part to clean Pad ASSY Pick roller Feed rollers Plastic rollers Eject rollers Sheet guides Glass Ultra sonic sensor Standard Cleaning Cycle Clean these parts after every 5,000 scans. ATTENTION The scanner must be cleaned more frequently if you scan any of the following type of sheets: • Documents of coated paper • Documents that are almost completely covered with printed text or graphics • Chemically treated documents such as carbonless paper • Documents containing a large amount of calcium carbonate • Documents written by pencil • Documents on which the toner is not fused sufficiently. For details on the cleaning the ADF, refer to section 3.2 "Cleaning the ADF" of "fi-5530C2 Operator's Guide" on the Setup CD-ROM." fi-5530C Image Scanner Getting Started AP-4