Garmin GAD 43e Installation Manual - Page 22

3.5.1 Wiring Harness Allow adequate space for installation of cables and connectors. The installer supplies and fabricates all of the cables. All electrical connections are made through a 50-pin D-subminiature connector provided by Garmin. Construct the wiring harness according to the information contained in this and the following sections. Cable lengths will vary depending upon installation. Strip all wires going to the connectors 0.17". Insert the wire into the pin and crimp with one of the recommended (or equivalent) crimping tools. Insert the pin into the connector housing location as specified by the interconnect drawings in APPENDIX C. Verify the pin is properly engaged into the connector by gently tugging on the wire. Route and secure the cable run from the GAD 43 to the other units away from sources of electrical noise. Section 4 provides I/O definition of all input and output signals. Required connectors and associated hardware are supplied with the connector kit. See APPENDIX C for interconnect wiring diagrams. CAUTION Check wiring connections for errors before connecting the cables to the GAD 43. Incorrect wiring could cause component damage. Table 3-1. Socket Contact Part Numbers Wire Gauge Garmin P/N Military P/N AMP Positronic ITT Cannon 50-pin connector (P431) 20-24 AWG 336-00022-00 M39029/63-368 N/A N/A N/A Table 3-2. Recommended Crimp Tools Manufacturer Military P/N Hand Crimping Tool M22520/2-01 Positronic ITT Cannon AMP Daniels Astro 9507 N/A N/A AFM8 615717 20-24 AWG (P431) Positioner Insertion/ Extract Tool M22520/2-08 M81969/14-02 M81969/1-02 9502-11 N/A N/A N/A N/A N/A K13-1 N/A 615724 N/A Notes: [1] Non-Garmin part numbers shown are not maintained by Garmin and are subject to change without notice. Page 3-2 Rev. B GAD 43 Installation Manual 190-00899-00