Garmin GPS 24xd Installation Instructions - Page 1

GPS 24XD NMEA 2000® INSTALLATION INSTRUCTIONS Important Safety Information CAUTION To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. NOTICE When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel. For the best performance and to avoid damage to your boat, read all installation instructions before proceeding. Install the device per these instructions. Use the appropriate fasteners, tools, and mounts listed, which are available at most marine dealers. The Garmin® GPS 24xd NMEA 2000 high-sensitivity GPS antenna provides position information to your existing NMEA 2000 network. If your boat does not have a NMEA 2000 network, you will need to install one. For more information, go to www.garmin.com. Tools Needed • Drill • 3.2 mm (1/8 in.) drill bit • 19 mm (3/4 in.) drill bit for a pole-mount cable-hole • 1 in. (25 mm) hole saw for a surface-mount cable-hole • Countersink bit for mounting on fiberglass • Screws for under-deck mounting • Screwdriver, appropriate for the screw type • Marine sealant (optional) • Additional NMEA 2000 network components as needed Mounting the Antenna Antenna Mounting Considerations CAUTION Do not install or store the antenna near strong magnets, including speakers. A strong magnetic field can damage the antenna. You can mount the antenna on a flat surface or attach it to a standard 1 in. OD, 14 threads per inch, pipe-threaded pole (not included). You can route the cable outside of the pole or through the pole. For best performance, consider these guidelines when selecting the antenna mounting location. • To ensure the best reception, the antenna should be mounted in a location that has a clear, unobstructed view of the sky in all directions . • The antenna should not be mounted where it is shaded by the superstructure of the boat , a radome antenna, or the mast. • The antenna should not be mounted near the engine or other sources of Electromagnetic Interference (EMI) . • The antenna should not be mounted near known ferrous metal objects such as a toolbox or compass. • A handheld compass should be used to test for magnetic interference in the area where the antenna is to be mounted. Your boat, motors, and devices must be on during the test. If the needle on the handheld compass moves when you hold it where you intend to mount the antenna, magnetic interference is present. You must choose another location and test again. • Mounting screws are provided with the antenna. If you use mounting hardware other than the provided screws, the hardware must be made of quality stainless steel or brass material to avoid magnetic interference with the antenna. NOTE: Test all mounting hardware with a handheld compass to make sure no magnetic fields are present in the hardware. • If a radar is present, the antenna should be mounted above the path of the radar . If necessary, the antenna may be mounted below the path of the radar . • The antenna should not be mounted directly in the path of the radar . • The antenna should not be mounted within 1 m (3 ft.) of a VHF radio antenna or the path of a radar . Testing the Mounting Location 1 Temporarily secure the antenna in the preferred mounting location and test it for correct operation. 2 If you experience interference with other electronics, move the antenna to a different location, and test it again. August 2020 GUID-28CE8C25-CFD8-4C12-B6D0-AD9CDF4D5084 v2