Garmin GPS 24xd Installation Instructions - Page 2
Surface Mounting the Antenna, Mounting the Antenna on a Pole
View all Garmin GPS 24xd manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
3 Repeat steps 1-2 until you observe full or acceptable signal strength. 4 Permanently mount the antenna. Surface Mounting the Antenna NOTICE If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer when the screws are tightened. Before you permanently mount the antenna, you must test the mounting location for correct operation (Testing the Mounting Location, page 1). 1 Using the surface-mount bracket as your mounting template, mark the three pilot-hole locations and trace the cable-hole in the center of the bracket. 2 Set the surface-mount bracket aside. Do not drill through the bracket. 3 Drill the three 3.2 mm (1/8 in.) pilot holes. 4 Drill the 19 mm (3/4 in.) cable hole in the center. 5 Use the included M4 screws to secure the surface-mount bracket to the mounting surface. 6 Route the cable through the center hole, and connect it to the antenna. 7 Verify the large gasket is in place on the bottom of the antenna, place the antenna on the surface-mount bracket, and twist it clockwise to lock it in place. 8 Secure the antenna to the mounting bracket with the included M3 screw . 9 Route the cable away from sources of electronic interference. Mounting the Antenna on a Pole Mounting the Antenna with the Cable Routed Outside the Pole Before you permanently mount the antenna, you must test the mounting location for correct operation (Testing the Mounting Location, page 1). 1 Route the cable through the pole-mount adapter , and place the cable in the vertical slot along the base of the pole-mount adapter. 2 Screw the pole-mount adapter onto a standard 1 in. OD, 14 threads per inch, pipe-threaded pole (not included). Do not overtighten the adapter on the pole. 3 Connect the cable to the antenna. 4 Place the antenna on the pole-mount adapter and twist it clockwise to lock it in place. 5 Secure the antenna to the adapter with the included M3 set screw . 6 With the antenna installed on the pole mount, fill the remaining gap in the vertical cable slot with a marine sealant (optional). 7 Attach the pole to the boat if it is not already attached. 8 Route the cable away from sources of electronic interference. Mounting the Antenna with the Cable Routed Through the Pole Before you permanently mount the antenna, you must test the mounting location for correct operation (Testing the Mounting Location, page 1). 1 Position a standard 1 in. OD, 14 threads per inch, pipe- threaded pole (not included) in the selected location, and mark the approximate center of the pole. 2 Drill a hole using a 19 mm (3/4 in.) drill bit for the cable to pass through. 3 Fasten the pole to the boat. 4 Thread the pole-mount adapter onto the pole. Do not overtighten the adapter. 5 Route the cable through the pole and connect it to the antenna. 6 Place the antenna on the pole-mount adapter and twist it clockwise to lock it in place. 7 Secure the antenna to the adapter with the included M3 set screw . 2