Garmin STRIKER 5cv Owner s Manual PDF - Page 13
Registering Your Device, Specifications, Troubleshooting - installation
View all Garmin STRIKER 5cv manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Appendix Registering Your Device Help us better support you by completing our online registration today. • Go to http://my.garmin.com. • Keep the original sales receipt, or a photocopy, in a safe place. If the original waypoint was taken from a map, there should be a legend on the map that lists the map datum and position format used to create that map. Most often this is found near the map key. 2 Select Settings > Units. 3 Select the correct map datum and position format settings. 4 Create the waypoint again. Specifications Temperature range Power source voltage range Rated current Measurement From -15° to 55°C (from 5° to 131°F ) From 10 to 20 V 1 A Troubleshooting My device does not turn on • Push the power cable all the way into the back of the device. Even if the cable seems to be connected, you should push firmly so that it is fully seated. • Make sure the power source is generating power. You can check this several ways. For example, you can check whether other devices powered by the source are functioning. • Check the fuse in the power cable. The fuse should be located in a holder that is part of the red wire of the power cable. Check that the proper size fuse is installed. Refer to the label on the cable or the installation instructions for the exact fuse size needed. Check the fuse to make sure there is still a connection inside of the fuse. You can test the fuse using a multimeter. If the fuse is good, the multimeter reads 0 ohm. • Check to make sure the device is receiving at least 10 Vdc, but 12 Vdc is recommended. To check the voltage, measure the female power and ground sockets of the power cable for DC voltage. If the voltage is less than 10 Vdc, the device will not turn on. My sonar does not work • Push the transducer cable all the way into the back of the device. Even if the cable seems to be connected, you should push firmly so that it is fully seated. • Check to make sure the sonar transmission is turned on. My device is not creating waypoints in the correct location You can manually enter a waypoint location to transfer and share data from one device to the next. If you have manually entered a waypoint using coordinates, and the location of the point does not appear where the point should be, the map datum and position format of the device may not match the map datum and position format originally used to mark the waypoint. Position format is the way in which the GPS receiver's position appears on the screen. This is commonly displayed as latitude/ longitude in degrees and minutes, with options for degrees, minutes and second, degrees only, or one of several grid formats. Map datum is a math model which depicts a part of the surface of the earth. Latitude and longitude lines on a paper map are referenced to a specific map datum. 1 Find out which map datum and position format was used when the original waypoint was created. Appendix 9