Garmin Vector 3/3S Owners Manual - Page 12
Troubleshooting
View all Garmin Vector 3/3S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Troubleshooting Updating the Vector Software Using the Edge 520, 820, 1000, or 1030 Before you can update the software, you must pair your Edge device to your Vector system. NOTE: The left pedal receives the software update. The left pedal sends the update to the right pedal. 1 Send your ride data to your Garmin Connect account. Garmin Connect automatically looks for software updates and sends them to your Edge device. 2 Bring your Edge device within range (3 m) of the sensor. 3 Rotate the crank arm a few times. The Edge device prompts you to install any pending software updates. 4 Follow the on-screen instructions. Resetting the Vector Pedals If the device stops responding, you may need to reset it by disconnecting and reconnecting the battery cover. This does not erase any of your data. 1 Use a 4 mm hex key to remove the battery cover . 2 Replace the cover, and hand tighten it. NOTE: Do not damage or lose the O-ring gasket. 3 Use a 4 mm hex key to gently tighten the battery cover. NOTE: Do not over-tighten the battery cover. The cover is sufficiently tight when the O-ring gasket is no longer visible. The pedal LED flashes red once. Performing a Static Torque Test NOTICE The static torque test is intended for advanced cyclists and installation experts. This test is not required under normal circumstances to achieve good results with the Vector system. This test is available for compatible Edge devices. Garmin recommends performing the static torque test a minimum of three times and averaging the reported torque values. 1 Go to www.support.garmin.com. 2 Enter your product name. 3 Enter "torque test" to view the FAQ topic. Following repeated static torque tests, if the reported torque value is consistently different than the expected value, you can enter a scale factor for one or both pedals. The scale factor is stored in the pedal and adjusts the power value that is calculated on the pedal. The scale factor is sent to the Edge device and stored on Edge device. 8 Appendix