Garmin Vector 3/3S Owners Manual - Page 5
Thank You, Getting Started, Tools Needed, Installing the Vector Components, Installing the Shoe - pedal
View all Garmin Vector 3/3S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Introduction WARNING Read all instructions carefully before installing and using the Vector system. Improper use could result in serious injury. See the Important Safety and Product Information guide in the product box for product warnings and other important information. NOTE: For more information, go to www.garmin.com/manuals /vector3 or www.support.garmin.com. 3 Insert the spindle into the crank arm. 4 Hand tighten the spindle. 5 Use the pedal wrench to tighten the spindle. Thank You Thank you for your Vector 3 or Vector 3S purchase. This manual covers both Vector systems. Vector was designed for cyclists, by cyclists, to provide an outstanding experience of owning a precision power measurement system for your bike. Vector is simple, accurate, and easy to use. Now it's time to put the power under your feet and get out there and ride. Getting Started 1 Install the Vector components (Installing the Vector Components, page 1). 2 Install the shoe cleats (Installing the Shoe Cleats, page 1). 3 Pair the Vector system with your Edge® device (Pairing Vector with Your Edge 1030, page 2). 4 Go for a ride (Your First Ride, page 2). 5 View your history (Vector Data, page 3). 6 Send your history to your computer (Sending Your Ride to Garmin Connect, page 3). Tools Needed • 15 mm pedal wrench • Bike grease • 3 mm hex key • 4 mm hex key Installing the Vector Components The installation steps for the Vector 3 and Vector 3S systems are very similar. Procedures that are specific to the Vector 3S system are noted. Preparing for the Installation 1 Remove the existing pedals. 2 Clean the threads, and remove old grease. Installing the Pedals This procedure is for the Vector 3 system. The Vector 3S system installation is the same, but the power sensor components are in the left pedal only. For more information, see About the Vector 3S System, page 2. 1 Install the right pedal first. 2 Apply a thin layer of grease on the pedal spindle threads. NOTE: Garmin® recommends torque of 25 lbf-ft. (34 N-m). 6 Repeat steps 2 through 5 to install the left pedal. NOTE: The left pedal spindle has a left-handed (reverse) thread. 7 Move your bike chain to the largest chain ring and the smallest cassette gear. 8 Rotate the crank arm to check for clearance. NOTE: Garmin recommends 2 mm or more between the pedal and the chain. If the pedal rubs the chain, you can add one washer (included) between the spindle and the crank arm to increase clearance. To maintain an equal q factor, you can add one washer to the left pedal spindle. Do not use more than one washer on each pedal. Pedal Status LED LED flashes indicate a system issue that requires your attention. Error codes are cleared after the issue is resolved and you have synced your Vector system with the Garmin Connect™ app or your Edge device. The LED is located on the inboard of the spindle . LED Activity 1 red flash 3 green flashes every 10 seconds Alternating red and green flashes 20 green flashes 20 red flashes 1 red flash every 10 seconds Status The Vector system is active and working properly. The pedal is searching for the other pedal. A software update is in progress. The software update was successful. The software update failed. The pedal batteries are low. Installing the Shoe Cleats NOTE: The left and right cleats are the same. 1 Apply a thin layer of grease on the cleat bolt threads. Introduction 1