Gastroback 40119 User Manual - Page 4

Gastroback recommends safety first

Page 4 highlights

Gastroback recommends safety first power point. • Always turn the appliance off and pull the plug when the appliance is not in use or when disassembling, moving or cleaning the appliance. Always grasp the plug to disconnect the appliance from the power outlet. • Do not leave food leftovers dehumidify on the appliance or units of the appliance. If pulp dehumidifies on the micro mesh filter it may clog the fine pores of the micro mesh filter thereby lessening the effectiveness of the juicer. Remove such dirt immediately and operate according to the instructions ´Care and cleaning` before you continue to proceed. • Never clean or operate the appliance or units of the appliance with abrasive or hard sharp-edged items. Use a nylon brush for cleaning the filter basket. • Never clean the motor block in the dishwasher. • Never use force operating the appliance to avoid damage of the units of the appliance. • Do not touch the small cutting blades in the base of the stainless steel filter basket. Pay attention not cutting yourself when handling the filter basket. • Always make sure the appliance is properly and completely assembled before connecting to power outlet and operating. The unit will not turn 'ON' unless properly assembled. • Do not push products into the feed chute with your fingers or foreign objects. Always use the food pusher provided. • Do not operate the appliance continuously more then 30 minutes. Allow the motor to rest for 30 minutes between each use. • Do not operate the appliance continuously on heavy loads for more than 10 seconds. In this case the appliance is overloaded or the fruit chunks are too big. Cut the fruit in smaller pieces and try smaller amounts at one time. To continue juicing turn the appliance OFF and then ON again. (None of the recipes in this book are considered a heavy load.) • While proceeding Do not push the food pusher too hard down. Empty the pulp container and juice jug in time to avoid run-over and splatter which might causes damages to the appliance. When proceeding hard or stringily food or if you press the stamp down too hard the motor could stop or slow down. In this case turn off the appliance immediately and pull the plug to avoid overheating. Operate according to the instructions ´Trouble shooting guide`. • Do not use the appliance if it is damaged or units of the appliance are damaged. Do not use the appliance if it does not function properly or if it was excessively loaded. The appliance is likely damaged if the appliance or units of the appliance show cracks, exorbitant wearing down, alterations or leaks. It is also likely damaged if the drive wheel of the motor block moves slowly. Take the appliance for technical maintenance and repair to an authorised specialised reparation shop. Reparation and technical maintenance of the appliance or line cord are just allowed to be accomplished by an authorised specialist reparation shop. • The appliance is not suitable for mincing nuts, chocolate or similar ingredients. The appliance is not suitable to make minced meet or to blend food. Important Safeguards for all Electrical Appliances • Always uncoil the line cord completely before installing the appliance. • Place the appliance close to a power point and connect it directly without using any extension cords to avoid additional risks of injury through fire or voltage. • Only install the appliance in proper form secure grounding receptacle with adequate electric power supply (alternating current; 220/230 V, 50/60 Hz) and ground fault circuit interrupter. The maximum power consumption of the appliance is 450 Watt. You should also install a fuse with a release current of maximum 30mA. If necessary ask your electrician for help. • Never pull, rip, bend, clamp, squish or knot the line cord. Pay attention to the line cord not hanging of the table. Attend to nobody getting caught in loops of the line cord or pulling the appliance of the work space. When pulling the plug always catch hold of the enclosure of the plug. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

4
Gastroback recommends safety first
power point.
• Always turn the appliance off and pull the
plug when the appliance is not in use or when
disassembling, moving or cleaning the appliance.
Always grasp the plug to disconnect the
appliance from the power outlet.
Do not leave food leftovers dehumidify on the
appliance or units of the appliance. If pulp
dehumidifies on the micro mesh filter it may clog
the fine pores of the micro mesh filter thereby
lessening the effectiveness of the juicer. Remove
such dirt immediately and operate according to the
instructions ´Care and cleaning` before you
continue to proceed.
Never clean or operate the appliance or units
of the appliance with abrasive or hard sharp-edged
items. Use a nylon brush for cleaning the filter basket.
Never clean the motor block in the dishwasher.
Never use force operating the appliance to
avoid damage of the units of the appliance.
Do not touch the small cutting blades in the
base of the stainless steel filter basket. Pay attention
not cutting yourself when handling the filter basket.
Always make sure the appliance is properly and
completely assembled before connecting to
power
outlet and operating. The unit will not turn ‘ON’
unless properly assembled.
Do not push products into the feed chute with
your fingers or foreign objects. Always use the
food pusher provided.
Do not operate the appliance continuously
more then 30 minutes. Allow the motor to rest
for 30 minutes between each use.
Do not operate the appliance continuously on
heavy loads for more than 10 seconds. In this
case the appliance is overloaded or the fruit
chunks are too big. Cut the fruit in smaller pieces
and try smaller amounts at one time. To continue
juicing turn the appliance OFF and then ON
again. (None of the recipes in this book are
considered a heavy load.)
While proceeding Do not push the food pusher
too hard down. Empty the pulp container and juice
jug in time to avoid run-over and splatter which
might causes damages to the
appliance. When
proceeding hard or stringily food or if you press
the stamp down too hard the motor could stop
or slow down. In this case turn off the appliance
immediately and pull the plug to avoid overheating.
Operate according to the instructions ´Trouble
shooting guide`.
• Do not use the appliance if
it is damaged or
units of the appliance are damaged. Do not use
the appliance if it does not function properly or if
it was excessively loaded. The appliance is likely
damaged if the appliance or units of the
appliance show cracks, exorbitant wearing
down, alterations or leaks. It is also likely damaged
if the drive wheel of the motor block moves slowly.
Take the appliance for technical maintenance
and repair to an authorised specialised reparation
shop. Reparation and technical maintenance of
the appliance or line cord are just allowed to be
accomplished by an authorised specialist reparation
shop.
• The appliance is not suitable for mincing nuts,
chocolate or similar ingredients. The appliance
is not suitable to make minced meet or to blend food.
Important Safeguards for all Electrical
Appliances
Always uncoil the line cord completely before
installing the appliance.
Place the appliance close to a power point
and connect it directly without using any extension
cords to avoid additional risks of injury through
fire or voltage.
• Only install the appliance in proper form
secure grounding receptacle with adequate
electric power supply (alternating current;
220/230 V, 50/60 Hz) and ground fault circuit
interrupter. The maximum power consumption of the
appliance is 450 Watt. You should also install a fuse
with a release current of maximum 30mA. If
necessary ask your electrician for help.
Never pull, rip, bend, clamp,
squish or knot the
line cord. Pay attention to the line cord not
hanging of the table. Attend to nobody getting
caught in loops of the line cord or pulling the
appliance of the work space. When pulling the
plug always catch hold of the enclosure of the plug.