Gateway 9510 Gateway 9510 Server User Guide - Page 90
connect to any installed devices., Reinstall the power supply modules by following the instructions
View all Gateway 9510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Replacing a power distribution module 14 Connect the power cables to chassis components and the system board. See "System board" on page 7 for connector locations on the system board. ■ Route the P1, P2, and P14 cables to the system board and connect to the appropriate connectors. ■ Route the longest power cables (P8, P9, P10, and P11) to the six-drive hot-swap drive bay and connect one cable to the drive back plane. ■ Route the shorter power cables (P3, P4, and P5) to the upper drive bay and connect to any installed devices. To system board To upper drive bay To 4-drive bay To 6-drive bay 15 Follow the instructions in "Installing the air ducts" on page 47. 16 Reinstall the power supply module(s) by following the instructions in "Replacing a power supply module" on page 81. 17 Follow the instructions in "Closing the server case" on page 52. 18 Connect power to the server and restart. www.gateway.com 85