Gateway FX510 8512066 - Gateway Reference Guide (for FX510 computers with Wind - Page 56
Adding or replacing an, optional diskette drive
View all Gateway FX510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
CHAPTER 4: Upgrading Your Computer 5 Slide the drive release latch toward the back of the computer to release the drive. 6 Slide the drive forward and out of the drive bay. 7 If you are replacing a drive, note any jumper settings on the old drive and set the jumpers on the new drive to be the same. If you are installing a new drive, follow the manufacturer's instructions. 8 Slide the new drive into the drive bay, line up the thumbscrew hole on the drive bay with the screw hole on the drive, then slide the drive release latch toward the front of the computer to lock the drive into place. You do not need to replace the thumbscrew because it was originally installed for shipping purposes. 9 Connect the drive cables using your notes from Step 3. If you are installing a new drive, follow the manufacturer's instructions. 10 Replace the front bezel by following the instructions in "Replacing the front bezel" on page 44. 11 Replace the side panel by following the instructions in "Replacing the side panel" on page 44. Adding or replacing an optional diskette drive To add or replace a diskette drive: 1 Remove the side panel by following the instructions in "Removing the side panel" on page 41. 2 Remove the front bezel by following the instructions in "Removing the front bezel" on page 43. 50