Gateway FX510 8512066 - Gateway Reference Guide (for FX510 computers with Wind - Page 61
Replace the side panel by following the instructions
View all Gateway FX510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
www.gateway.com 4 Remove the hard drive by sliding it out of the drive bay. 5 Note any jumper settings on the old drive and set the jumper on the new drive to be the same. If you are installing a new drive, follow the manufacturer's instructions. Jumper 6 Slide the new drive into the drive bay, then secure it in the drive bay by sliding the drive release latch in toward the computer. 7 If you are replacing a drive, reconnect the drive cables using your notes from Step 3. If you are installing a new drive, follow the manufacturer's instructions for connecting it to the system board. 8 Replace the side panel by following the instructions in "Replacing the side panel" on page 44. 9 Reconnect all external cables and the power cord. 10 Turn on your computer. 11 If you installed a new drive, format and partition the drive according to the manufacturer's instructions (available on the manufacturer's Web site). 55