GE AV447FBS Installation Instructions - Page 10

Remove Filter, Remove Wiring Cover

Get GE AV447FBS PDF manuals and user guides View all GE AV447FBS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Installation Instructions 2 5(029((;+$867$'$3725 ,IH[KDXVWLQJYHQWLQJXVLQJWKH1ø4s[s rectangular GXFW³RSWLRQDOIRU-9-9-9-9-9 -9DQG$9PRGHOVRQO\ Remove the exhaust adaptor from the inside of the hood. Set it aside along with its mounting screws.  REMOVE WIRING COVER Remove the ZLULQJFRYHU from inside the hood. Set the cover and its mounting screws aside. Wiring cover 31ø4s x 10s rectangular exhaust adaptor and screws 3 REMOVE FILTER Remove the shipping tape holding the metal grease ILOWHUin place. Pull down on the center of the front edge of the filter. The filter will then slip out of the retaining tabs on the back. 6 5(029(:,5,1*.12&.287 Remove either the top or the back wiring knockout as needed and install an approved VWUDLQUHOLHIFODPS. Top knockout Strain relief clamp Back knockout Strain relief clamp Metal grease filter 4 5(9(56(7+(%$))/()25'8&7(' ,167$//$7,21621/

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
10
1
4
rectangular
Remove the exhaust adaptor from the inside of the hood.
Set it aside along with its mounting screws.
3
1
4
x 10
rectangular
exhaust
adaptor
and screws
REMOVE FILTER
Remove the shipping tape holding the
metal grease
in place. Pull down on the center of the front edge
of the filter. The filter will then slip out of the retaining
tabs on the back.
If the hood is to be recirculated, skip to the next step.
Remove the baffle from the top of the hood. Reinstall
the baffle so the short side marked “VENTED” is visible.
The long side of the baffle should be inside the hood.
REMOVE WIRING COVER
Remove the
from inside the hood.
Set the cover and its mounting screws aside.
Wiring
cover
Remove either the top or the back wiring knockout as
needed and install an approved
.
2
3
4
6
Metal grease filter
Installation Instructions
“VENTED” is visible
Strain relief
clamp
Back
knockout
Top
knockout
Strain relief
clamp
If
recirculating
, non-vented ductless (JN327 and RN328,
and optional for JV247, JV248, JV347, JV348, JV367 and
AV447 models only),
Using a flat-blade screwdriver, remove the appropriate
from the top or back of the hood.
3
1
4
Rectangular
Remove top rectangular
duct knockout only.
7
Remove circular duct
knockout only.
3
1
4
Rectangular horizontal
discharge.
Remove rear
rectangular duct knockout only.
7