GE DCVH485EKMS Use and Care Manual - Page 8
About cycle options. - lighting
UPC - 084691191261
View all GE DCVH485EKMS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Safety Instructions Operating Instructions About cycle options. NOTE: Not all features are available on all dryer models. Extend Tumble Minimizes wrinkles by adding approximately 20 minutes of constant no-heat tumbling followed by 70 minutes of intermittent no-heat tumbling after clothes are dry. The dryer is in EXTENDED TUMBLE when the ESTIMATED CYCLE TIME display is illuminated in a circular pattern. The light in the button will light up when EXTEND TUMBLE is on. NOTE: It is normal for the drum to pause for short periods of time during EXTEND TUMBLE. Damp Alert This option causes the dryer to beep when clothes have dried to a damp level. Remove items that you wish to hang dry. The DAMP ALERT will only beep when this option is selected (dry cycle keeps running). Removing clothes and hanging them when they are damp can reduce the need to iron some items. The light in the button will light up when DAMP ALERT is on. NOTE: Only for DRY, MORE DRY and EXTRA DRY sensor dry selections. Delay Start Use to delay the start of your dryer. 1. Choose your dry cycle and any options. 2. Press the DELAY START button. You can change the delay time in 1-hour increments (up to 18 hours) each time you press the DELAY START button. Stop pressing the button when your desired time is displayed. 3. Press the START/PAUSE button to start the countdown. The countdown time will be shown in the ESTIMATED TIME REMAINING display. NOTES: ■ If the door is opened while the dryer is in DELAY, the countdown time will continue to count down the delay time. If the door is not closed and the countdown time expires, the cycle will not start until the door is closed and the START/PAUSE button is pressed. ■ You can delay the start of a dryer cycle up to 18 hours. The light in the button will light up when DELAY START is on. Troubleshooting Tips Consumer Support 8