GE DSXH43GFWW Owners Manual - Page 7

Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support About your dryer features. CYCLE SIGNAL OFF LOUD WRINKLE CARE EXTENDED COOL AIR TUMBLE ON OFF Cycle Signal Option (on some models) When the signal is on it will sound just five minutes as a reminder to remove before the end of the cycle to remind the load. you to remove the clothes. The signal can be set at OFF (no sound), LOUD or anywhere in between. If the dried load cannot be removed promptly during the EASY CARE cycle, the Cycle Selector will advance to the EXTENDED COOL DOWN setting. Unheated tumbling continues during EXTENDED COOL DOWN and WRINKLE CARE (on some models) for 40 minutes to help reduce wrinkling. When the CYCLE SIGNAL is on, it will sound briefly every NOTE: I If items are removed before the end of the cycle, turn the CYCLE SELECTOR knob to OFF. I Remove garments promptly at the sound of the signal. Place clothes on hangers so wrinkles won't set in. I Use the Cycle Signal especially when drying fabrics like polyester knits and permanent press. These fabrics should be removed so wrinkles won't set in. Wrinkle Care Option (on some models) Use this option to minimize the wrinkles in clothes. It provides approximately 15 minutes of no-heat tumbling after the clothes are dry. This option can only be used with the EASY CARE and DELICATES cycles. Light cover Pry with flat blade screwdriver Light housing Replacing the Dryer Light Bulb (on some models) WARNING: To reduce the risk of electric shock, disconnect this appliance from the power supply before attempting any user maintenance. Turning the controls to the OFF position does not panel by removing the fuse or switching off the circuit breaker. To replace the dryer light: 1 Using a small flat blade screwdriver, pry the bottom of the light cover out and off the light housing. disconnect this appliance from the power supply. 2 Unscrew the bulb when cool and replace it with an appliance bulb of The dryer light is located above the dryer the same or lower wattage. door opening. Before replacing the light bulb, be sure to 3 Snap the light cover back on the light housing. unplug the dryer power cord or disconnect the dryer at the household distribution Drying Rack (on some models) A handy drying rack may be used for drying articles such as stuffed toys, pillows or washable sweaters. 1 Remove the lint screen. 2 Place the front bar under the lip of the lint screen opening. 3 When items are dry, remove the rack and replace the lint screen. DO NOT OPERATE THE DRYER WITHOUT THE LINT SCREEN IN PLACE UNLESS THE DRYING RACK IS IN PLACE. NOTE: I The drying rack must be used with the TIMED DRY cycle. I Do not use this drying rack when there are other clothes in the dryer. 7