GE GDT530PSDSS Installation Instructions - Page 7
Dishwasher Installation
View all GE GDT530PSDSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Dishwasher Installation STEP 5: INSTALL 90° ELBOW • Wrap a 90° elbow with thread seal tape. • Thread 90° elbow Water Valve onto the water valve. Bracket • Do not overtighten elbow. Water valve bracket could bend or water valve fitting could break. • Position the end of Thread Seal the elbow to face the Tape rear of the dishwasher. Front of Dishwasher 90° Elbow Fill Hose Figure K STEP 7: POSITION WATER LINE AND HOUSE WIRING • Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher. 4" 4" 6" 6" STEP 6: INSTALL DRAIN HOSE TO DRAIN LOOP Connect drain loop end to drain hose using the screw clamp as shown in the figure. Figure M Water House Line Wiring Figure L STEP 8: INSTALL DRAIN HOSE, THROUGH CABINET • Position dishwasher in front of cabinet opening. Insert drain hose into the hole in cabinet side. If a power cord is used, guide the end through a separate hole. Insulation Blanket Maximum Drain Hose Length 10' Water Line Drain Hose House Wiring Power Cord (If Used) Figure N Tip: Prevent unnecessary service call charges for fill, drain or noise concerns. Position utility lines so they do not interfere with anything under or behind the dishwasher. 7