GE GDT530PSDSS Installation Instructions - Page 8
Dishwasher Installation, IMPORTANT, IMPORTANT - parts
View all GE GDT530PSDSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Dishwasher Installation STEP 9: SLIDE DISHWASHER THREE-FOURTHS OF THE WAY INTO CABINET IMPORTANT - Do not push against front panel with knees. Damage will occur. • Grasp the sides of the front panel and slide dishwasher into the opening a few inches at a time. STEP 11: INSTALL MOUNTING BRACKETS You will need the mounting brackets and 2 #8 hex-head screws set aside in Step 1. You must install the mounting brackets onto the dishwasher tub frame top or sides prior to sliding the dishwasher into place under the countertop. Install mounting brackets on top if the underside of countertop is wood or wood-like material that accepts screws: IMPORTANT - After installing brackets and before closing the dishwasher door, adjust the brackets by bending them up as needed, so that they do not contact the top of the dishwasher door and cause damage. Figure O Do not push against front door panel with knee. Damage to the door panel will occur. • As you proceed, pull the drain hose through the opening under the sink. Stop pushing when the dishwasher extends about 6 inches forward of adjacent cabinets. • Make sure drain hose is not kinked under or behind the dishwasher. • Make certain the house wiring, drain line and water line do not interfere with components under dishwasher. Top Mounting #8 Bracket Screw Dishwasher tub frame Bracket Bend and break here after installing if counter has a short overhang. STEP 10: INSTALL TRIM PIECES (on some models) Skip this step if trim is not supplied with the dishwasher. In this step you will need the trim pieces set aside in Step 1. • Position the trim pieces so the lips face toward the dishwasher door. • Select a trim piece and press it onto the left side tub flange. Start with the top edge and press the trim piece completely onto the tub flange as you move towards the bottom. Repeat for the right side tub flange trim piece. Trim Strip Trim Strip Top View Figure P If you would like to order the Trim Kit from GE Service, please call 800.GE.Cares and request part number WD08X10094 for BB models or WD08X10096 for WW or CC models. 8 • If you are installing the dishwasher under a counter with a short overhang, the countertop brackets may extend beyond the edge of the counter. If this is the case, remove the excess length by repeatedly bending the brackets at the front notch only until they break. Install mounting brackets on sides if the countertop is granite or similar material that will not accept wood screws: • Break off front portion of the tab with pliers at the location shown. • Position the left-hand side bracket as shown. Repeat with the right bracket. Side Mounting Dishwasher tub frame #8 Bracket Screw Bend and break here if necessary Bracket