GE GLDT696JSS Installation Instructions - Page 10

Installation Instructions STEP 13 - CONNECT DRAIN LINE FOLLOW ALL LOCAL CODES AND ORDINANCES. The drain hose molded end will fit 5/8", 3/4" or 1" diameter connections on the air gap, waste tee or disposer. Cut on the marked line as required for your installation. CuttCinugttLiningesLines DRAIN LINE INSTALLATION • Connect drain line to air gap, waste tee or disposer using either previously determined method. Method 1 - Air gap with waste tee or disposer 1" 3/4" 5/8" IMPOIMRTPAONRTTA: NDTo: nDoot cnuott ccourtrcuograrutegdated por tpiorntionf hoof sheose • If a longer drain hose is required, add up to 42" of length for a total of 10 ft. to the factory installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with hose clamps. Waste Tee Installation Disposer Installation Method 2 - High drain loop with waste tee or disposer Fasten to underside of countertop Fasten to underside of countertop 32" 18" Min. 18" Min. Min. CCoouupler HoHsoeseClCalammpp Hose Clamp • Secure the drain hose to the air gap, waste tee or disposer with clamps. NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET FOR PROPER DRAIN OPERATION. Waste Tee Installation Disposer Installation IMPORTANT - When connecting drain line to disposer, check to be sure that drain plug has been removed. DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE. Remove Drain Plug TIP: Avoid unnecessary service call charges. Always be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer. 10