GE GLDT696JSS Installation Instructions - Page 6
Installation Instruction
View all GE GLDT696JSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation Instruction STEP 2 - ADJUST LEVELING LEGS • Move the dishwasher close to the installation location and lay it on its back. AdjAudsjtutsot to InstIanslltaatlilaotnion HeigHhetight • Measure installation height and dishwasher height. Extend leveling legs out from the dishwasher base, 1/4" less than installation height. STEP 3 - REMOVE TOEKICK • Remove the 2 toekick screws. Lift off the 2 piece toekick. 2-Screws NOTE: You may have to open the dishwasher door to access the toekick screws. CAUTION: Dishwasher may tip forward if the door is opened. PRECAUCIÓN: El lavavajillas se puede caer hacia delante si la puerta es abierta. STEP 4 - INSTALL POWER CORD Skip this step if dishwasher will be direct wired. The power cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordinances. Recommended power cord length is 54" min. and 64" max. A Remove junction box cover B Check that white, black and green dishwasher wires are threaded through hole in back Ground White Black E Replace junction box cover D Use UL Listed wire nuts C Insert power cord wires through strain relief and tighten Connect incoming power cord white (or ribbed) to dishwasher white. Black (or smooth) to black. Ground to dishwasher green wire. Use UL Listed wire nuts of appropriate size. Replace junction box cover. Be sure wires are not pinched under the cover. STEP 5 - INSTALL 90° ELBOW • Wrap 90° elbow with thread seal tape on both threads. • Install a 90° elbow onto the water valve. Fill Hose 90 ° Elbow Thread Seal Tape Water Valve Bracket • Do not over tighten 90° elbow, water valve bracket could bend or water valve fitting could break. • Position the end of the elbow to face the rear of the dishwasher. 6