GE GSC3500DWW Owners Manual - Page 6
Connecting and disconnecting your dishwasher - faucet adapter
![]() |
View all GE GSC3500DWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Connecting and disconnecting your dishwasher Safety Instructions Operating Instructions Troubleshooting Tips Collar Unicouple collar CONNECT THE UNICOUPLE TO THE FAUCET • Run garbage disposer, if you have one, • Turn on the hot water faucet and check to clean out the disposer and thus allow for leaks. If a unicouple leak was observed, water to drain from the sink through the take whatever actions are necessary to disposer and down the drain. repair the leak. This may be as simple as • Run hot water faucet to purge cold tightening the faucet adapter. Or, it may water from the hot water line. The hot require the services of a plumber if water water must be between 120°F and is leaking from the interface between the 150°F for best wash performance. moveable faucet arm and the fixed part of • Roll the dishwasher to a position just in the faucet fastened to the sink. front of the sink. • Pull the unicouple and its hoses completely out from storage compartment at rear of the dishwasher. • Attach the unicouple to the faucet adapter following the three steps below: -- Depress the locking collar at the top of the unicouple. -- Place the unicouple completely over Note: The unicouple's small hose carries water from the faucet to the dishwasher. The large hose carries water from the dishwasher to the sink. Orient the faucet with the unicouple attached so water from the unicouple will run into the sink drain. • Plug the dishwasher power cord into the electrical outlet. the faucet adapter. -- Release the locking collar. The unicouple should now be locked onto the faucet adapter. DISCONNECT AND STORE YOUR DISHWASHER Remove Power • Unplug the dishwasher. • Feed power cord back into its storage location. Remove Unicouple from Faucet • Turn off hot water. • Relieve water pressure from the unicouple assembly before disconnecting it from the faucet by depressing the red pressure relief button Depress red button to release water pressure on the unicouple. • Depress the locking collar and remove the unicouple from the faucet. • Drain excess water from the unicouple. If the sink is 34" or higher from the floor, the excess water in unicouple hoses cannot be drained directly into the sink. Depress collar to release unicouple from faucet It will be necessary to drain excess water from hoses into a bowl or suitable container that is held outside and lower than the sink. • Feed the unicouple and hoses back into Unicouple collar their storage pocket. Store the Dishwasher Unicouple • Latch the dishwasher door closed. • Roll the dishwasher into its storage location. 6 Consumer Support
![](/manual_guide/products/general-electric-gsc3500dbb-owners-manual-aa93d2e/6.png)