GE JAP02SNSS Use and Care Manual - Page 13

Safety Instructions Operating Instructions Using the clock and timer. (on some models) Not all features are on all models. To Set the Clock The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle. Touch the CLOCK pad twice. Touch the + or - pads. Touch the START/ON pad until the time of day shows in the display. This enters the time and starts the clock. To check the time of day when the display is showing other information, simply touch the CLOCK pad. The time of day shows until another pad is touched. Make sure the clock is set to the correct time of day. If the + or - pads are not touched within one minute after you touch the CLOCK pad, the display reverts to the original setting. If this happens, touch the CLOCK pad and reenter the time of day. The timer is a minute timer only. The OFF pad does not affect the timer. To Set the Timer The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes. Touch the TIMER pad. Touch the + or - pads until the amount of time you want shows in the display. The maximum time that can be entered in minutes is 59. Times more than 59 minutes should be changed to hours and minutes. If you make a mistake, touch the TIMER pad and begin again. Touch the START/ON pad. The time will start counting down, although the display does not change until one minute has passed. When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the TIMER pad is touched. Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support 13