GE JGP989 Owners Manual - Page 30

Installation Instructions FINAL ASSEMBLY 18 ASSEMBLE BURNERS, CHECK IGNITION Assemble burner as shown. Grate Electrode Curved side toward the center Burner cap Burner head Burner base 19 INSTALL DOWNDRAFT FILTER, VENT GASKET AND VENT GRILLE Do not operate the vent without the filter in place. • Place the filter diagonally through the vent opening. Vent Filter Vent Chamber CAUTION: Do not operate the burner without all burner parts in place. Medium Head and Cap Medium Head and Cap B A B A B C B Front of Cooktop C Small Head and Cap Large Head and Cap • Make sure it rests, at an angle, on the supports in the vent opening. Place the burner heads on the burner bases matching the letters. Place the caps on the heads. Make sure that the heads and caps are placed on the correct size burner. The burner heads and burner bases are labeled A, B and C to aid reassembly. There is one small (A), two medium (B) and one large (C) head and cap. Make sure the notch in the burner head is positioned toward the electrode. Rotate the burner head around the burner base until it is level and securely seated. Place the grates over the burners. Check for proper ignition: • Push in one control knob and turn to LITE position. • The igniter will spark and the burner will light; the igniter will cease sparking when the burner is lit. • First test may require some time, while air is flushed out of the gas line. • Turn knob to OFF. • Repeat the procedure for each burner. 30 • Fit the vent grille gasket around the edge of the downdraft vent opening. Make sure the front of the gasket is installed toward the front of the cooktop. • Carefully place the vent grille onto the gasket on the downdraft opening. Grille Vent Grille Gasket CHECK OPERATION OF DOWNDRAFT • Turn the vent fan speed control to HI, MED and LO to make sure all speeds operate correctly.