GE JP3036SLSS Installation Instructions - Page 1

Installation 30 and 36" Instructions Electric Cooktop - Radiant Excludes Down-Draft Models If you have questions, call GE Appliances at 800.GE.CARES (800.432.2737) or visit our website at: GEAppliances.com. BEFORE YOU BEGIN Read these instructions carefully and completely. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the consumer. • Note to Consumer - Keep these instructions for future reference. • Product failure due to improper installation is not covered under the Warranty. • WARNING This appliance must be properly grounded. • ATTENTION INSTALLER ALL COOKTOPS MUST BE HARD WIRED (DIRECT WIRED) INTO AN APPROVED JUNCTION BOX. A "PLUG AND RECEPTACLE" IS NOT PERMITTED ON THESE PRODUCTS. • Proper installation is the responsibility of the installer and product failure due to improper installation is NOT covered under warranty. PARTS INCLUDED 4 Screws (WB01X1137) Foam Tape WB06K5042 2 Hold Down Brackets MATERIALS YOU WILL NEED Junction Box Wire Nuts TOOLS NEEDED 90º or Straight Squeeze Connector for 1" Conduit Pencil Phillips Head Screwdriver Saber Saw Ruler or Straightedge 1/8" Drill Bit & Electric or Hand Drill Safety Glasses CUTTING THE COUNTERTOP If you are installing the cooktop in a solid surface material such as granite, quartz or any other natural or synthetic solid surface, we recommend that the cutout be prepared by a professional cabinet or countertop installer. Cooktop cutouts in wood or wood-laminate countertops may be able to be prepared using a saber saw and electric drill. 31-11072-1 04-17 GEA