GE JP3036SLSS Installation Instructions - Page 5
Installation Instructions, PREPARING THE OPENING Cont
View all GE JP3036SLSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installation Instructions PREPARING THE OPENING (Cont) 3 MINIMUM CLEARANCES TO ADJACENT WALLS & CABINETS 13" max. Depth of unprotected overhead cabinets 30" min. Clearance from countertop to unprotected overhead surface 30" min. for 30" cooktop 36" min. for 36" cooktop 1 1/2" min. (30") and 2" min. (36") Clearance from cutout to nearest vertical wall or cabinet on right side of the unit below the 15" MIN. clearance height. 5 VERTICAL CLEARANCE Allow 5" minimum vertical clearance from the cooktop bottom (or 8-1/4" 8-1/4" minimum depth from the countertop) to any combustible surfaces, such as a cabinet drawer. 5" DDRRAAWWEERR 2" min. Clearance from cutout to nearest vertical wall or cabinet on left side of the unit below the 15" MIN. clearance height. 15" min. Clearance from countertop to underside of nearest cabinets on both sides of cooktop, including any light rails. If a 30" clearance between the cooktop and overhead combustible materials or metal cabinet cannot be maintained, then a minimum clearance of 24" is required and the underside of the cabinets above the cooktop must be protected with not less than 1/4" insulating millboard covered with sheet metal not less than 30 gage (0.0125") thick. A ventilation hood may be installed above the cooktop. See the ventilation hood installation instructions for the appropriate dimensions and clearances. 4 Make sure the wall coverings, countertop and cabinets around the cooktop can withstand heat (up to 200°F) generated by cooktop. Wall covering, cabinets and countertop must withstand heat up to 200°F. 6 For Americans with Disabilities Act (ADA) Forward Approach Installation Only: 5" For models with no drop box, allow 5" minimum depth between the countertop and an enclosure. (JP3030, JP3530, JP3036, and JP3536) For electronic touch and backlit knob models, allow 6-1/2" minimum depth between the countertop and an enclosure. (All other models) 6 1/2" Drop box NOTE: The enclosure must be made of wood material. Also, an access panel is required for the junction box, hold-down brackets, and service. 31-11072-1 5