GE JVM3160RFSS Installation Instructions - Page 18

Mount The Microwave Oven, Assemble And Install Adaptor - handle

Get GE JVM3160RFSS PDF manuals and user guides View all GE JVM3160RFSS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Installation Instructions B4 ASSEMBLE AND INSTALL ADAPTOR Damper Blower Plate 1 Place the microwave oven in its upright position, with the top of the unit facing up and the front of the unit facing toward you. 2 Remove the screw on the back side of the blower plate and raise the blower plate off of the microwave. 3 Slide the damper from left to right into the tabs on the blower plate. The yellow tape on the damper should be facing away from you. 4 Remove the yellow tape from the damper. 0DNHVXUH WKDWWKHGDPSHUSLYRWVHDVLO\EHIRUHPRXQWLQJ PLFURZDYHRYHQ You will need to make adjustments to assure proper alignment with your house exhaust duct after the microwave oven is installed. 5 Position the blower plate with damper back on the microwave and secure it with the screws that were removed. B5 MOUNT THE MICROWAVE OVEN CAUTION: 7RDYRLGWKHULVNRISHUVRQDO LQMXU\ EDFNLQMXU\RURWKHULQMXULHVGXHWRH[FHVVLYH ZHLJKWRIWKHPLFURZDYH RUSURSHUW\GDPDJH\RX ZLOOQHHGWZRSHRSOHWRLQVWDOOWKLVPLFURZDYH IMPORTANT: Do not grip or use handle during installation. WARNING: 5LVNRI(OHFWULF6KRFN&DQ FDXVHLQMXU\RUGHDWK,ILQVWDOOLQJXQLWZLWKPHWDO FRXQWHUWRSVFRYHUWKHHGJHRIWKHSRZHUVXSSO\ FRUGKROHZLWKWKHSRZHUVXSSO\FRUGEXVKLQJ IMPORTANT: If filler blocks are not used, case damage may occur from overtightening screws. NOTE: When mounting the microwave, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift microwave oven by pulling cord. 1 Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. Power Cord Convenience Cooking Popcorn Beverage Potato Reheat Defrost Weight/Time Cook Time Express Cook 12 45 Timer On/Off 3 Add 30 Sec. 6 Turntable 78 Power Level 0 9 Surface Light Set Clock Vent Cancel Off Start Pause 2 Rotate front of microwave oven up against cabinet bottom. 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
18
Installation Instructions
MOUNT THE MICROWAVE OVEN
B5
CAUTION:
IMPORTANT:
Do not grip or use handle during
installation.
WARNING:
IMPORTANT:
If filler blocks are not used, case damage
may occur from overtightening screws.
NOTE:
When mounting the microwave, thread power
cord through hole in bottom of top cabinet. Keep it
tight throughout Steps 1–3. Do not pinch cord or lift
microwave oven by pulling cord.
Lift microwave, tilt it forward, and hook slots at
back bottom edge onto four lower tabs of mounting
plate.
Rotate front of microwave oven up against cabinet
bottom.
1
2
Power Cord
ASSEMBLE AND INSTALL ADAPTOR
B4
Place the microwave oven in its upright position, with
the top of the unit facing up and the front of the unit
facing toward you.
Remove the screw on the back side of the blower
plate and raise the blower plate off of the microwave.
Slide the damper from left to right into the tabs on the
blower plate. The yellow tape on the damper should
be facing away from you.
Remove the yellow tape from the damper.
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
microwave oven is installed.
Position the blower plate with damper back on the
microwave and secure it with the screws that were
removed.
1
2
3
4
5
Damper
Blower
Plate